Abstract:Hybrid silica monoliths functionalized with octyl groups and dedicated to chromatographic separations in the reversed-phase mode were directly synthesized within capillaries according to the protocol described by Yan et al. [L.J. Yan, Q.H. Zhang, Y.Q. Feng, W.B. Zhang, T. Li, L.H. Zhang, Y.K. Zhang, J. Chromatogr. A 1121 (2006) 92]. Although these monoliths allowed reaching high efficiencies in capillary electrochromatography (CEC), serious limitations prohibited their application in nano-liquid chromatography (nano-LC). Such limitations observed as poor performances in the nano-LC mode and the lack of reproducibility of the synthesis were related to the longitudinal morphological inhomogeneities of the hybrid material along the capillary. Thus, several modifications were conducted in the synthesis protocol in order to improve the resulting morphology of the monolith making it suitable for nano-LC separations. The influence of several critical parameters (such as the addition temperature of the basic catalyst and the hydrolysis duration) on the textural and chromatographic properties had been extensively studied. It was found that a decrease (i.e. 0 degrees C) of the temperature addition of the basic catalyst associated with a shorter hydrolysis duration (1h instead of 6h) allowed (i) delaying the gelation time and consequently facilitating the capillary filling step, (ii) increasing the structural homogeneity of the hybrid monoliths, i.e. their chromatographic performances in nano-liquid chromatography also (iii) greatly improving the reproducibility of the synthesis within the capillary without impairing the material's carbon load, i.e. the incorporation of the less hydrolysable C(8) precursor. The resulting hybrid monoliths afforded retention factors comparable to that previously obtained for C(18) grafted silica monoliths and efficiencies that are the best ever recorded in nano-LC with hybrid monoliths and that are close to the ones achieved with grafted silica monoliths. In fact, this modified protocol allowed a significant improvement of the performances in nano-LC which could be observed by the decrease of the mean value of H(min) going from 123 microm (Yan's protocol) to 24 microm (modified protocol) for a same length of capillary (l = 8.5 cm). In addition, the reproducibility of the synthesis was greatly improved through a factor six of reduction on the calculated standard deviation of these efficiencies. The high permeability and longitudinal homogeneity of the synthesized monolith allowed increasing the capillary length (for example, a 75-cm capillary was conveniently filled with hybrid silica monolith) and the column could be eluted at a very low backpressure leading to chromatographic performances up to 40,000 plates. Finally, the good efficiencies in the nano-LC mode combined with the excellent performances already present in the CEC mode led to fast (less than 1 min) and high efficient separations in the pressurized capillary electrochromatography (p-CEC) mode.

A novel polymeric monolith prepared with multi-acrylate crosslinker for retention-independent efficient separation of small molecules in capillary liquid chromatography

Effectiveness of the Early Addition of Rosiglitazone to Control Hyperglycemia after Unsuccessful Submaximal Sulphonylurea Monotherapy: The Rosiglitazone Early versus SULphonylurea Titration (RESULT) Study

Primary renal allograft dysfunction.

Fluoride use in periodontal therapy: a review of the literature.

[Psychopathology and achievement motivation in adolescents with pathological internet use].

Preparation and Application of Chiral Monolithic Column for Capillary Liquid Chromatography

A Graphitized-Carbon Monolithic Column

Optimization of the single-step synthesis of hybrid C(8) silica monoliths dedicated to nano-liquid chromatography and capillary electrochromatography

Prepared Polymethacrylate-Based Monoliths for the Separation of Cations by Non-Suppressed Capillary Ion Chromatography.

Preparation of dye-ligand affinity chromatographic packings based on monodisperse poly(glycidylmethacrylate-co-ethylenedimethacrylate) beads and their chromatographic properties.

Poly(glycidyl methacrylate- co -ethylene glycol dimethacrylate) Monolith with Dual Porosity for Size Exclusion Chromatography

Rapid Separation of Proteins by Capillary HPLC on a Short Polymethacrylate‐based Strong Cation‐exchange Monolithic Column

Preparation and characterization of inorganic silica-organic polymer mixture based C16 capillary monolithic column

A novel one‐pot strategy of preparation of N ‐phenylacrylamide‐styrene co‐polymer open tubular capillary column for peptides separation

Polyacrylamide-based monolithic capillary column with coating of cellulose tris(3,5-dimethylphenyl-carbamate) for enantiomer separation in capillary electrochromatography.

Fabrication of highly crosslinked and monodispersed silicon-containing polymeric microspheres via photo-initiated polymerization and their application in capillary liquid chromatography

Modulation of intracellular glutathione concentration alters dehydropyrimidine dehydrogenase activity in peripheral blood mononuclear cells

Polyethylene glycol diacrylate-based supermacroporous monolithic cryogel as high-performance liquid chromatography stationary phase for protein and polymeric nanoparticle separation.

Preparation of Poly(trimethyl-2-methacroyloxyethylammonium Chloride-Co-ethylene Glycol Dimethacrylate) Monolith and Its Application in Solid Phase Microextraction of Brominated Flame Retardants.

Preparation and evaluation of hydrophilic C18 monolithic sorbents for enhanced polar compound retention in liquid chromatography and solid phase extraction

Polymer Monoliths with Exchangeable Chemistries: Use of Gold Nanoparticles As Intermediate Ligands for Capillary Columns with Varying Surface Functionalities