Abstract:The metering mode is gradually changing from volumetric metering to energy metering under the open-access operation of gas pipelines. The gas component tracking by operating simulation is an effective method to realize the energy metering of gas networks. In this paper, coupling and decoupling transient component tracking models of gas networks are proposed. The pipeline governing equations, compressor equations, valve equations, and node relationship equations are considered in the proposed models. The implicit central difference method and the damped Newtonian method are adopted to solve the models. The coupling model considers the component tracking part and hydraulic-thermal simulation as a whole, while the decoupling model splits the whole process into the gas component tracking part, the parameters calculation part, and the hydraulic-thermal simulation part. In the component tracking part, the spatiotemporal variation of the gas mass fraction and density can be obtained through the input velocity of each node. Then, the parameters in the gas state equation can be solved, the hydraulic-thermal simulation can be performed, and the new velocity of each node can be calculated. The iteration for each time step ends if the deviation of flow velocity in the component tracking process and the hydraulic-thermal process satisfies the requirements. Two cases are studied to verify the effectiveness of the proposed models, and the boundary condition adaptability of the transient simulation models is analyzed. The proposed models can efficiently simulate the spatiotemporal variation of the operating variables and gas components, providing a reference in the operation of natural gas pipeline networks.

Investigation of gas purging process in pipeline by numerical method

Study on length of mixed region during gas purging in pipeline

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Investigation of Gas Compression Process for Reciprocating Compressor

Numerical Simulation on Filling Process of Drag Reduction Agent in Natural Gas Pipeline

Numerical Simulation of Low Pressure Natural Gas Injector

Experimental Investigation on Performance and Heat Release Analysis of a Pilot Ignited Direct Injection Natural Gas Engine

Research on Simulation of Gas Pipeline Leak Detection and Location

Dynamic modeling and characteristic analysis of natural gas network with hydrogen injections

Applied Research on Dynamic Characteristics of a Conventional Fuel Injection Piping

The investigation of gas–liquid two-phase transient flow based on Steger–Warming flux vector splitting method in pipelines

Experimental and Numerical Study on Novel Combustor for Mixture of Purge Gas and Crude Gas

Numerical Simulation for Perforation-Caused Leakage Diffusion of Buried Gas Pipeline

A transient gas pipeline network simulation model for decoupling the hydraulic-thermal process and the component tracking process

Analysis of Improving the Desorption Performance of Natural Gas Vehicle Tank Using Engine Cooling Water

THE NUMERICAL SIMULATION RESEARCH OF GAS ENTRAINMENT BASED ON THREE-DIMENSIONAL MODEL

Performance Investigation and Optimization of the Primary Separation Part of the Oil-Gas Separator

Experimental and numerical investigations on flow field characteristics of pintle injector

Simulation and Experiment on Double Pipelines Gas Engine-driven Heat Pump System

Numerical investigations on pilot ignited high pressure direct injection natural gas engines: A review