Abstract:Various mechanical properties of single-walled carbon nanotubes (SWCNT) and double-walled carbon nanotubes (DWCNT) are evaluated using molecular dynamics (MD) simulations. A tensioning process was first performed on a SWCNT whose interaction is based on the Brenner’s ‘second generation’ potential under varying length–diameter ratios and strain rates, in order to understand the SWCNT’s behaviour under axial tension. The results showed an increase in the SWCNT’s ultimate tensile strength and a decrease in critical strain given the conditions of increasing strain rate and a decreasing length–diameter ratio. Comparison was done with previous studies on axial tensioning of SWCNT to validate the results obtained from the set-up, based on the general stress–strain relationship and key mechanical properties such as the strain at failure and the Young’s modulus. A DWCNT was then constructed, and Lennard-Jones ‘12-6’ potential was used to describe the energy present between the nanotube layers. Extraction of the inner tube in a DWCNT was performed using two inner wall tubings of different diameters to draw comparison to the energies needed to separate fully the outer and inner tubing. Finally, a bending test was performed on two DWCNTs with different intertube separations. Insights into the entire bending process were obtained through analyses of the variations in the strain energy characteristic of the surface atoms near the bending site, as the DWCNT is gradually bent until failure.

Predicted Mechanical Properties of Carbon Nanotube-Based Structures

Role of Nitrogen on the Mechanical Properties of the Novel Carbon Nitride Nanothreads

Engineering the Mechanical Properties of Graphene Nanotube Hybrid Structures Through Structural Modulation

Carbon-nanotube-templated Carbon Nanofibers with Improved Mechanical Performance

Numerical Exploration Of The Defect'S Effect On Mechanical Properties Of Nanowires Under Torsion

Mechanical Properties of Connected Carbon Nanorings Via Molecular Dynamics Simulation

The Controllable Mechanical Properties of Coiled Carbon Nanotubes with Stone–Wales and Vacancy Defects

Predicting mechanical properties of carbon nanosprings based on molecular mechanics simulation

Mechanical Properties of Single-Walled (5,5) Carbon Nanotubes with Vacancy Defects

Simulation of the Elastic Response and the Buckling Modes of Single-Walled Carbon Nanotubes

Mechanical properties of carbon-nanotube with topological defects

Characterization of Single-Walled Carbon Nanotubes with Nodal Structural Defects

Mechanical properties of carbon nanotube by molecular dynamics simulation

Mechanical behaviour of BC<sub>3</sub> compound and pure carbon nanotubes with topological defects

Buckling and axially compressive properties of perfect and defective single-walled carbon nanotubes

Molecular dynamics simulation studies of mechanical properties of different carbon nanotube systems

Machine Learning-Assisted High-Throughput Molecular Dynamics Simulation of High-Mechanical Performance Carbon Nanotube Structure

Structural Analysis for Tensile Behavior of Silicon-Carbon Core-Shell Nanotube

Tensile Loading Of Double-Walled And Triple-Walled Carbon Nanotubes And Their Mechanical Properties

Computational Studies on Mechanical Properties of Carbon Nanotori

Predicting the elastic properties of single-walled carbon nanotubes