Abstract:Sorption-enhanced steam reforming of ethanol (SE-SRE) with in-situ CO2 removal is an environmentally friendly and sustainable approach for hydrogen production. Researches on continuous production of high-purity H2 by SE-SRE over the modified Li4SiO4 sorbent were conducted using two parallel reactor in this work. The low cost Li4SiO4 derived from rice husk ash (RHA) is a promising high-temperature CO2 sorbent. However, the poor adsorption kinetics of RHA-Li4SiO4 sorbent at low CO2 concentration is the major challenge. The metallic elements (K, Ca, Al, Mg) were employed to modify the RHA-Li4SiO4 for efficient CO2 capture. The developed sorbents were characterized and tested to study the role of dopants on the crystal, textural, microstructure and CO2 adsorption kinetics and cyclic stability. Results indicated that K doping effectively inhibited the growth of crystal aggregation and resulted in a fluffy morphology with abundant pores and higher specific surface area, while the addition of Ca, Al and Mg formed a nubby structure with larger particle size. K-doped RHA-Li4SiO4 exhibited the best CO2 uptake properties and the optimal K doping molar content was 0.02 with the maximum capture capacity of 34.16 wt%, which is higher than 27.1 wt% of pure RHA-Li4SiO4. Then, the effect of operating conditions on the enhancement behaviors was considered in the SE-SRE system. High-purity H2 (above 96%) was achieved by coupling K(0.02)/RHA-Li4SiO4 sorbent with Ni-based catalyst under the optimum condition (T: 525 °C, liquid hourly space velocity: 0.9 mL/(g·h), sorbent/catalyst: 4 and steam/carbon: 8.0). The adsorption activity of K(0.02)/RHA-Li4SiO4 maintained at a high level in ten SE-SRE/regeneration cycles. Finally, a scheme including two parallel fixed-bed reactors was designed and operated periodically for continuous production of high-purity H2. The reaction switching time was shown to depend strongly on the pre-breakthrough time and operating conditions. As the reaction switching time was 40 min, the products were always only H2 and CH4 (no CO and CO2 appear) and the H2 purity remained above 90% during 400 min, confirming high purity hydrogen stream can be obtained continuously.

High-Purity Hydrogen Production by Sorption-Enhanced Steam Reforming of Ethanol: A Cyclic Operation Simulation Study

The Characteristics of Sorption Enhanced Steam Methane Reforming for Hydrogen Production on a Complex Catalyst

The ReSER-COG Process for Hydrogen Production on a Ni–CaO/Al2O3 Complex Catalyst

Hydrogen Production via Sorption Enhanced Steam Reforming of Bio-Ethanol Using Nano Ca-Based Adsorbents

Thermodynamic Simulation of Hydrogen Production from the Nano-Cao Reactive Sorption Enhanced Biomass Steam Reforming

The calculation and experimental study of reactive sorption enhanced steam reforming of modeled biogas for hydrogen production

Thermodynamic calculations for reactive sorption enhanced reforming of C2/C3 light hydrocarbons

Sorption-Enhanced Steam Reforming of Glycerol for Hydrogen Production over a NiO/NiAl2O4 Catalyst and Li2ZrO3-Based Sorbent

Continuous high-purity hydrogen production by sorption enhanced steam reforming of ethanol over modified lithium silicate

Simulation of a sorption-enhanced water gas-shift pilot technology for pure hydrogen production from a waste gasification plant

Recent Advances and Prospects in High Purity H 2 Production from Sorption Enhanced Reforming of Bio-Ethanol and Bio-Glycerol As Carbon Negative Processes: A Review

Absorption-Enhanced Methanol Steam Reforming for Low-Temperature Hydrogen Production with Carbon Capture

Development of Pure Hydrogen Generation System Based on Methanol Steam Reforming and Pd Membrane

Continuous Production of Hydrogen from Sorption-Enhanced Steam Methane Reforming in Two Parallel Fixed-Bed Reactors Operated in a Cyclic Manner

High-purity hydrogen production by sorption-enhanced methanol steam reforming over a combination of Cu–Zn–CeO2–ZrO2/MCM-41 catalyst and (Li–Na–K) NO3·MgO adsorbent

High-purity hydrogen production by sorption-enhanced steam reforming of iso-octane over a Pd-promoted Ni-Ca-Al-O bi-functional catalyst

Ni-CaO-CaZrO3 Bi-Functional Materials for High Purity Hydrogen Production Via Sorption Enhanced Steam Reforming of Ethanol

Standalone ethanol micro-reformer integrated on silicon technology for onboard production of hydrogen-rich gas

Nickel-Calcium-Zirconium bi-functional materials for high purity hydrogen production via sorption enhanced steam reforming of ethanol

Hydrogen production and geometry optimization of ethanol steam reforming combining water gas shift reaction in a crossflow membrane tube reactor

Hydrogen Production from Sorption-Enhanced Steam Reforming of Phenol over a Ni–Ca–Al–O Bifunctional Catalyst