Abstract:Accurate prediction of limit cycle oscillations resulting from combustion instability has been a long-standing challenge. The present work uses a coupled approach to predict the limit cycle characteristics of a combustor, developed at Cambridge University, for which experimental data are available (Balachandran, Ph.D. thesis, 2005). The combustor flame is bluff-body stabilised, turbulent and partially-premixed. The coupled approach combines Large Eddy Simulation (LES) in order to characterise the weakly non-linear response of the flame to acoustic perturbations (the Flame Describing Function (FDF)), with a low order thermoacoustic network model for capturing the acoustic wave behaviour. The LES utilises the open source Computational Fluid Dynamics (CFD) toolbox, OpenFOAM, with a low Mach number approximation for the flow-field and combustion modelled using the PaSR (Partially Stirred Reactor) model with a global one-step chemical reaction mechanism for ethylene/air. LES has not previously been applied to this partially-premixed flame, to our knowledge. Code validation against experimental data for unreacting and partially-premixed reacting flows without and with inlet velocity perturbations confirmed that both the qualitative flame dynamics and the quantitative response of the heat release rate were captured with very reasonable accuracy. The LES was then used to obtain the full FDF at conditions corresponding to combustion instability, using harmonic velocity forcing across six frequencies and four forcing amplitudes. The low order thermoacoustic network modelling tool used was the open source OSCILOS (http://www.oscilos.com). Validation of its use for limit cycle prediction was performed for a well-documented experimental configuration, for which both experimental FDF data and limit cycle data were available. The FDF data from the LES for the present test case was then imported into the OSCILOS geometry network and limit cycle oscillations of frequency 342 Hz and normalised velocity amplitude of 0.26 were predicted. These were in good agreement with the experimental values of 348 Hz and 0.21 respectively. This work thus confirms that a coupled numerical prediction of limit cycle behaviour is possible using an entirely open source numerical framework.

Time domain simulations of nonlinear thermoacoustic behaviour in a simple combustor using a wave-based approach

Experimental Study on Self-Excited Thermoacoustic Instabilities and Intermittent Switching of Azimuthal and Longitudinal Modes in an Annular Combustor

Computational investigations of the coupling between transient flame dynamics and thermo-acoustic instability in a self-excited resonance combustor

Simplified Models for the Thermodynamic Properties along a Combustor and Their Effect on Thermoacoustic Instability Prediction

Prediction of combustion instability limit cycle oscillations by combining flame describing function simulations with a thermoacoustic network model

Time-domain Numerical Simulation of High Frequency Combustion Instability in Liquid Propellant Rocket Engines

Comparison of strongly and weakly nonlinear flame models applied to thermoacoustic instability

Thermoacoustic instability analysis of a laminar lean premixed flame under autoignitive conditions

Numerical prediction of combustion instability limit cycle oscillations for a combustor with a long flame

Prediction Method for Instability Boundaries of Self-Excited Oscillation Combustion in a Model Combustor

Analytical Solutions of Acoustic Field in Annular Combustion Chambers with Non-Uniform Cross-Sectional Surface Area and Mean Flow

Nonlinear Dynamic Characteristics of Self-Excited Thermoacoustic Instabilities in Premixed Swirling Flames

Predicting thermoacoustic stability characteristics of longitudinal combustors using different endpoint conditions with a low Mach number flow

Stability Study of a Nonlinear Thermoacoustic Combustor: Effects of Time Delay, Acoustic Loss and Combustion-Flow Interaction Index

Effect of distributed heat source on low frequency thermoacoustic instabilities

Dynamics and control of premixed combustion systems based on flame transfer and describing functions

Experimental Investigation of Thermoacoustic Instabilities for A Model Combustor with Varying Fuel Components

Combustion Instability Analysis on a Partially Premixed Swirl Combustor by Thermoacoustic Experiments and Modeling

Flame Macrostructures and Thermoacoustic Instabilities in Stratified Swirling Flames

Experimental Study of Equivalence Ratio and Fuel Flow Rate Effects on Nonlinear Thermoacoustic Instability in a Swirl Combustor

Identification of flame transfer function and mechanism analysis of the influence of boundary impedance characteristics on thermoacoustic instability