Entropy in Nanofluids
Giulio Lorenzini,Omid Mahian
DOI: https://doi.org/10.3390/e20050339
IF: 2.738
2018-01-01
Entropy
Abstract:first_page settings Order Article Reprints Font Type: Arial Georgia Verdana Font Size: Aa Aa Aa Line Spacing: Column Width: Background: Open AccessEditorial Entropy in Nanofluids by Giulio Lorenzini 1 and Omid Mahian 2,3,* 1 Department of Engineering and Architecture, University of Parma, Parco Area delle Scienze 181/A, Parma 43124, Italy 2 Center for Advanced Technologies, Ferdowsi University of Mashhad, Mashhad 91775-1111, Iran 3 School of Aeronautic Science and Engineering, Beihang University, Beijing 100191, China * Author to whom correspondence should be addressed. Entropy 2018, 20(5), 339; https://doi.org/10.3390/e20050339 Received: 26 April 2018 / Revised: 1 May 2018 / Accepted: 1 May 2018 / Published: 3 May 2018 (This article belongs to the Section Thermodynamics) Download Download PDF Download PDF with Cover Download XML Download Epub Browse Figure Versions Notes The study on entropy generation and exergy analysis in Nanofluid flows started in 2010 [1]. After this date, many other studies have been done on this topic such as [2,3,4,5,6]. Figure 1 shows the increase in the number of research and review articles in the field of entropy generation in nanofluid flows. The data are obtained from Scopus, by searching the keywords of “Nanofluids” or “Nanofluid” and “Entropy Generation” or “Exergy”. As shown, the interest to this subject has increased year by year so that in 2017 the number of articles reached more than 100. Because of high interest toward this area, in 2016 and 2017 we decided to serve as guest editors for two special issues on nanofluids. The total number of articles that have been published in the two special issues are 21 articles with more than 200 citations. The high number of citations shows the significance of this topic for researchers. Here, we give a summary of papers published in these two issues. In the first paper, Kolsi et al. [7] studied three-dimensional entropy generation due to natural convection in a cavity where a diamond-shaped body was installed in the middle of cavity. They used Al2O3–water nanofluid as the working fluid. It was found that total entropy generation increases with the increasing volume fraction of nanoparticles. In References [8,9,10,11,12], entropy generation due to nanofluid flow on stretching/shrinking surfaces has been studied at different conditions. Freidoonimehr et al. [13] modeled the magneto-hydrodynamics nanofluid flow over a porous disk by considering soret and dufour effects through the Homotopy Analysis Method. Li et al. [14] studied the entropy generation of Al2O3–water nanofluids in a microchannel with flow control devices including cylinder, rectangle, protrusion, and v-groove. They concluded that protrusion devices are the best option to achieve minimum entropy generation. In another work, Xie et al. [15] studied the effect of nanofluid on the entropy generation in rectangular channels with dimples and protrusions. It was encouraged to use dimples and protrusions in the channel since these reduce entropy generation. They showed that using nanoparticles, especially at low Reynolds numbers, leads to decreases in entropy generation. Rashidi et al. [16] studied the entropy generation of MHD blood flow of nanofluid due to peristaltic waves. Abbas [17] investigated analytically the entropy generation in the flow of peristaltic nanofluids in channels with compliant walls. Chamkha et al. [18] examined the entropy generation due to natural convection of Cu–water nanofluids in C-shaped cavity where a magnetic force is applied to the flow. Selimefendigil [19] simulated the entropy generation in an entrapped trapezoidal cavity with MHD flow using Al2O3–water nanofluid. Sheremet et al. [20] evaluated the entropy generation in a square cavity where a solid body was installed inside it using nanofluid. Nasiri et al. [21] studied the flow of Fe3O4–water nanofluid in a microchannel heat sink with offset fan-shaped reentrant cavities. Qasim et al. [22] simulated the entropy generation due to methanol-based nanofluid flow in a sinusoidal wavy channel. Bhatti et al. [23] determined the entropy generation on electro-kinetically modulated peristaltic propulsion in a microchannel using nanofluids by considering joule heating. Baskaya et al. [24] presented the entropy generation in an inclined channel under a magnetic field where a ferrofluid (Cu–water) fills the channel. Sheremet et al. [25] solved the entropy generation due to natural convection flow of nanofluids in a cavity with non-uniform distribution of temperature on the left wall by considering the effects of Brownian motion and thermophoresis. In the last work, Al-Rashed et al. [26] studied the entropy generation due to 3D natural convection flow of Carbon Nanotubes(CNTs)–water nanofluids in a square cavity where a baffle with arbitrary velocity could rotate inside it.In most of the studies mentioned above, it was concluded that adding nanoparticles leads to heat transfer enhancement, and on the other hand, entropy generation reduces with an increase in the volume concentration of nanoparticles.It is suggested for future studies that authors:Investigate the effects of different thermophysical models (especially correlations developed based on experimental data) on entropy generation rate;Use both two-phase mixture model and single-phase models and compare the results;Investigate new configurations;Investigate entropy generation in new application of nanofluids, as most of the present studies are limited to classic problems such as flow on sheets or inside cavities and ducts;Consider the prediction of entropy generation using soft computing approaches like neural network;Conduct a comparison between entropy generation rates of different nanoparticles and base fluids to recognize the optimum nanofluid from the second law of thermodynamics viewpoint. Conflicts of InterestThe author declare no conflict of interest.ReferencesSingh, P.K.; Anoop, K.B.; Sundararajan, T.; Das, S.K. Entropy generation due to flow and heat transfer in nanofluids. Int. J. Heat Mass Transf. 2010, 53, 4757–4767. [Google Scholar] [CrossRef]Mahian, O.; Mahmud, S.; Wongwises, S. Entropy Generation Between Two Rotating Cylinders with Magnetohydrodynamic Flow Using Nanofluids. J. Thermophys. Heat Transf. 2012, 27, 161–169. [Google Scholar] [CrossRef]Mahian, O.; Kianifar, A.; Kleinstreuer, C.; Al-Nimr, M.A.; Pop, I.; Sahin, A.Z.; Wongwises, S. A review of entropy generation in nanofluid flow. Int. J. Heat Mass Transf. 2013, 65, 514–532. [Google Scholar] [CrossRef]Nouri, D.; Pasandideh-Fard, M.; Javad Oboodi, M.; Mahian, O.; Sahin, A.Z. Entropy generation analysis of nanofluid flow over a spherical heat source inside a channel with sudden expansion and contraction. Int. J. Heat Mass Transf. 2018, 116, 1036–1043. [Google Scholar] [CrossRef]Siavashi, M.; Bahrami, H.R.T.; Saffari, H. Numerical investigation of porous rib arrangement on heat transfer and entropy generation of nanofluid flow in an annulus using a two-phase mixture model. Numer. Heat Transf. Part A Appl. 2017, 71, 1251–1273. [Google Scholar] [CrossRef]Ghanbarpour, M.; Khodabandeh, R. Entropy generation analysis of cylindrical heat pipe using nanofluid. Thermochim. Acta 2015, 610, 37–46. [Google Scholar] [CrossRef]Kolsi, L.; Mahian, O.; Öztop, H.F.; Aich, W.; Borjini, M.N.; Abu-Hamdeh, N.; Aissia, H.B. 3D buoyancy-induced flow and entropy generation of nanofluid-filled open cavities having adiabatic diamond shaped obstacles. Entropy 2016, 18, 232. [Google Scholar] [CrossRef]Bhatti, M.M.; Abbas, T.; Rashidi, M.M.; Ali, M.E.S.; Yang, Z. Entropy generation on MHD eyring–powell nanofluid through a permeable stretching surface. Entropy 2016, 18, 224. [Google Scholar] [CrossRef]Bhatti, M.; Abbas, T.; Rashidi, M.; Ali, M. Numerical Simulation of Entropy Generation with Thermal Radiation on MHD Carreau Nanofluid towards a Shrinking Sheet. Entropy 2016, 18, 200. [Google Scholar] [CrossRef]Qing, J.; Bhatti, M.M.; Abbas, M.A.; Rashidi, M.M.; Ali, M.E.S. Entropy generation on MHD casson nanofluid flow over a porous Stretching/Shrinking surface. Entropy 2016, 18, 123. [Google Scholar] [CrossRef]Rashidi, M.M.; Abbas, M.A. Effect of Slip Conditions and Entropy Generation Analysis with an Effective Prandtl Number Model on a Nanofluid Flow through a Stretching Sheet. Entropy 2017, 19, 414. [Google Scholar] [CrossRef]Almakki, M.; Dey, S.; Mondal, S.; Sibanda, P. On Unsteady Three-Dimensional Axisymmetric MHD Nanofluid Flow with Entropy Generation and Thermo-Diffusion Effects on a Non-Linear Stretching Sheet. Entropy 2017, 19, 168. [Google Scholar] [CrossRef]Freidoonimehr, N.; Rashidi, M.M.; Abelman, S.; Lorenzini, G. Analytical modeling of MHD flow over a permeable rotating disk in the presence of soret and dufour effects: Entropy analysis. Entropy 2016, 18, 131. [Google Scholar] [CrossRef]Li, P.; Xie, Y.; Zhang, D.; Xie, G. Heat transfer enhancement and entropy generation of nanofluids laminar convection in microchannels with flow control devices. Entropy 2016, 18, 134. [Google Scholar] [CrossRef]Xie, Y.; Zheng, L.; Zhang, D.; Xie, G. Entropy generation and heat transfer performances of Al2O3–water nanofluid transitional flow in rectangular channels with dimples and protrusions. Entropy 2016, 18, 148. [Google Scholar] [CrossRef]Rashidi, M.M.; Bhatti, M.M.; Abbas, M.A.; Ali, M.E.S. Entropy generation on MHD blood flow of nanofluid due to peristalticwaves. Entropy 2016, 18, 117. [Google Scholar] [CrossRef]Abbas, M.A.; Bai, Y.; Rashidi, M.M.; Bhatti, M.M. Analysis of entropy generation in the flow of peristaltic nanofluids in channels with compliant walls. Entropy 2016, 18, 90. [Google Scholar] [CrossRef]Chamkha, A.; Ismael, M.; Kasaeipoor, A.; Armaghani, T. Entropy generation and natural convection of CuO-water nanofluid in C-shaped cavity under magnetic field. Entropy 2016, 18, 50. [Google Scholar] [CrossRef]Selimefendigil, F.; Öztop, H.F.; Abu-Hamdeh, N. Natural convection and entropy generation in nanofluid filled entrapped trapezoidal cavities under the influence of magnetic field. Entropy 2016, 18, 43. [Google Scholar] [CrossRef]Sheremet, M.A.; Oztop, H.F.; Pop, I.; Abu-Hamdeh, N. Analysis of entropy generation in natural convection of nanofluid inside a square cavity having hot solid block: Tiwari and Das’ model. Entropy 2016, 18, 9. [Google Scholar] [CrossRef]Nasiri, M.; Rashidi, M.M.; Lorenzini, G. Effect of magnetic field on entropy generation in a microchannel heat sink with offset fan shaped. Entropy 2016, 18, 10. [Google Scholar] [CrossRef]Qasim, M.; Khan, Z.H.; Khan, I.; Al-Mdallal, Q.M. Analysis of entropy generation in flow of methanol-based nanofluid in a sinusoidal wavy channel. Entropy 2017, 19, 490. [Google Scholar] [CrossRef]Bhatti, M.M.; Sheikholeslami, M.; Zeeshan, A. Entropy Analysis on Electro-Kinetically Modulated Peristaltic Propulsion of Magnetized Nanofluid Flow through a Microchannel. Entropy 2017, 19, 481. [Google Scholar] [CrossRef]Baskaya, E.; Komurgoz, G.; Ozkol, I. Investigation of oriented magnetic field effects on entropy generation in an inclined channel filled with ferrofluids. Entropy 2017, 19, 377. [Google Scholar] [CrossRef]Sheremet, M.A.; Grosan, T.; Pop, I. Natural Convection and Entropy Generation in a Square Cavity with Variable Temperature Side Walls Filled with a Nanofluid: Buongiorno’s Mathematical Model. Entropy 2017, 19, 337. [Google Scholar] [CrossRef]Al-Rashed, A.A.A.A.; Aich, W.; Kolsi, L.; Mahian, O.; Hussein, A.K.; Borjini, M.N. Effects of movable-baffle on heat transfer and entropy generation in a cavity saturated by CNT suspensions: Three-dimensional modeling. Entropy 2017, 19, 200. [Google Scholar] [CrossRef] Figure 1. Number of articles on entropy generation in nanofluid flow. Figure 1. Number of articles on entropy generation in nanofluid flow. © 2018 by the authors. Licensee MDPI, Basel, Switzerland. This article is an open access article distributed under the terms and conditions of the Creative Commons Attribution (CC BY) license (http://creativecommons.org/licenses/by/4.0/). Share and Cite MDPI and ACS Style Lorenzini, G.; Mahian, O. Entropy in Nanofluids. Entropy 2018, 20, 339. https://doi.org/10.3390/e20050339 AMA Style Lorenzini G, Mahian O. Entropy in Nanofluids. Entropy. 2018; 20(5):339. https://doi.org/10.3390/e20050339 Chicago/Turabian Style Lorenzini, Giulio, and Omid Mahian. 2018. "Entropy in Nanofluids" Entropy 20, no. 5: 339. https://doi.org/10.3390/e20050339 Find Other Styles Note that from the first issue of 2016, MDPI journals use article numbers instead of page numbers. See further details here. Article Metrics No No Article Access Statistics For more information on the journal statistics, click here. Multiple requests from the same IP address are counted as one view.