Experimental and numerical investigation on out-of-plane ultimate strength of high-strength steel arches
Zhenyu Pan,Hanwen Lu,Airong Liu,Jialin Wang,Mark A. Bradford
DOI: https://doi.org/10.1016/j.tws.2024.111898
IF: 5.881
2024-04-25
Thin-Walled Structures
Abstract:This study presents an experimental investigation on the out-of-plane ultimate strength of high-strength-steel (HSS) I-section arches, which has not been reported previously. Fourteen I-section HSS arches having different yield strengths, cross-sectional dimensions, slendernesses, and rise to span ratios were tested under three-point symmetrical vertical loading. The corresponding out-of-plane deformation modes and strengths are identified. Subsequently, in order to predict the out-of-plane capacities of HSS arches, a finite element analyses is carried out, which takes into consideration residual stresses and initial geometrical imperfections. This analysis demonstrates a strong alignment with the experimental results, confirming the accuracy of finite element model and experimental results. Furthermore, the study comprehensively analyzes the influence of yield strength of steel, rise-span ratio, and slenderness on the ultimate bearing capacity of HSS arches. Through a parametric analysis, design formulas for the out-of-plane bearing capacity of HSS arches subjected to arbitrary compression forces combined with arbitrary bending moments are formulated. It is found that the out-of-plane ultimate strength of HSS arches is significantly influenced by the yield strength of the steel. Compared to a low strength steel (LSS) arch, the out-of-plane ultimate bearing capacity of the HSS arch increases with an increase in yield strength in the plastic stage, and the ultimate lateral displacement of the HSS arch decreases with an increase in yield steel strength due to the lower ductility of HSS. In addition, after reaching the out-of-plane ultimate bearing load of arch, the load-displacement curve of the HSS arch drops faster than the LSS arch. It is also found that the proposed design formulas can effectively predict the out-of-plane bearing capacity of HSS arches.
engineering, mechanical,mechanics, civil