Abstract:The strengthening of timber beams with carbon-fibre-reinforced polymers (CFRP) has been widely used in the last decades to enhance the behaviour of historical or new timber structures, usually for bending. While considerable improvement in capacity and ductility is typically achieved, the increase in stiffness was, in many cases, well short of analytical expectations, which tend to overestimate stiffness. This study addresses the problem by investigating the underlying mechanical behaviour using experimental, analytical, and numerical tools on a sample of Norway spruce (Picea abies) beams reinforced with carbon-fibre fabric. In the experimental program, each beam is tested for bending with and without CFRP reinforcement in order to determine specimen-specific stiffness increase on an individual basis. The reinforcement yielded an increase of 27% in capacity, 53% in ultimate displacement, and 133% in compliance, verifying its efficiency. Axial compression tests on an independent sample are also performed to verify modulus of elasticity in compression. Numerical computations based on a beam model and a three-dimensional finite element model are performed with the introduction of separate moduli of elasticity for tension and compression in timber. Inverse computation using the experimental load–deflection curves yielded the moduli and the compression yield stress of timber to provide the best match between tests and simulations. The mean difference of only 6% in stiffness between FEM and the tests is obtained. The dominance of normal stresses in the longitudinal direction is found, in correspondence with the experimentally observed tensile failure of timber (apart from a few defected specimens). Compression yield stresses are within 7% (beam model) and 2% (FEM) error compared with the control axial tests. The differences between FE simulations and tests in ultimate load and compliance are within 1%. This study concludes that the application of CFRP in the composite beams enables the determination of timber material properties opposed to pure timber beams without reinforcement, and the adoption of separate moduli of elasticity for tension and compression leads to adequate modelling of reinforced timber beams.

Flexural Performance of Small Fir and Pine Timber Beams Strengthened with Near-Surface Mounted Carbon-Fiber-Reinforced Polymer (nsm Cfrp) Plates and Rods

Investigation on Flexural Performance of RC Beams Flexurally Strengthened by Side-bonded CFRP Laminates

Effect of sustaining load level on flexural behavior of RC beams retrofitted with CFRP sheets

Behavior of Preloaded RC Beams Strengthened with CFRP Laminates

Study on flexural performance of cracked RC beams retrofitted with CFRP sheets

EXPERIMENTAL STUDY ON FLEXIONAL BEHAVIOR OF TIMBER BEAM STRENGTHENED WITH FRP

Prestressed Glulam Beams Reinforced with CFRP Bars

Study on Flexural Behavior of Timber Beams Strengthened with FRP

Flexural performance test of carbon fiber reinforced composite sandwich beams with cedarwood core

Flexural Behavior of Frp and Steel Reinforced Glulam Beams: Experimental and Theoretical Evaluation

Flexural Performances of Pre-Stressed Concrete Piles Reinforced with Hybrid BFRP and Steel Bars

Study on Flexural Behaviour of Glulam Beams Reinforced by Near Surface Mounted (NSM) CFRP Laminates

Experimental, Analytical, and Numerical Assessments for the Controversial Elastic Stiffness Enhancement of CFRP-Strengthened Timber Beams

Flexural Behavior of Reinforced Concrete Beams Strengthened with Hybrid Carbon-Pet FRP Laminates

Experimental and Theoretical Investigation on Shear Behaviour of Small-Scale Timber Beams Strengthened with Fiber-Reinforced Polymer Composites

Experimental study on flexural behavior of RC beams strengthened with FRP/SMA composites

Flexural performance of reinforced concrete beams strengthened using near-surface-mounted carbon-fiber-reinforced polymer bars: Effects of bonding patterns

Experimental Study on the Flexure Property of Bamboo-Wood-gfrp Sandwich Beams

Experimental and theoretical study on flexural behavior of steel-concrete composite beams strengthened by CFRP plates with unbonded retrofit systems

Experimental Study on Flexural Performances of Concrete Beams Strengthened with Near-Surface Mounted (NSM) FRP Reinforcement

Flexural Performance of Concrete Beams Reinforced with Continuous FRP Bars and Discrete Steel Fibers under Cyclic Loads