Hot Deformation and Work Hardening Behavior of an Extruded Mg–Zn–Mn–Y Alloy

N. Tahreen,D. F. Zhang,F. S. Pan,X. Q. Jiang,D. Y. Li,D. L. Chen

DOI: https://doi.org/10.1016/j.jmst.2015.10.001

2015-01-01

Abstract:The aim of this study was to evaluate the strain hardening and hot deformation behavior of as extruded Mg-Zn-Mn (ZM31) magnesium alloy with varying Y contents (0.3, 3.2, and 6 wt%) via compression testing along the extrusion direction at room temperature, 200 degrees C and 300 degrees C. Texture and phases were identified by X-ray diffraction. Alloy ZM31 + 0.3Y consisted of a mixture of fine equiaxed grains and elongated grains with I-phase (Mg3YZn6); alloy ZM31 + 3.2Y contained I-phase and W-phase (Mg3Y2Zn3); alloy ZM31 + 6Y had long-period stacking-ordered (LPSO) X-phase (Mg12YZn) and Mg24Y5 particles. With increasing Y content the basal texture became weakened significantly. While alloys ZM31 + 0.3Y and ZM31 + 3.2Y exhibited a skewed true stress-true stain curve with a three-stage strain hardening feature caused by the occurrence of {10 (1) over bar2} extension twinning, the true stress-true stain curve of alloy ZM31 + 6Y was normal due to the dislocation slip during compression. With increasing temperature the extent of skewness decreased. While the compressive yield stress, ultimate compressive stress, strain hardening exponent, and hardening capacity all decreased as the temperature increased, the retention of the high-temperature deformation resistance increased with increasing Y content mainly due to the presence of thermally-stable LPSO X-phase. Copyright (C) 2015, The editorial office of Journal of Materials Science & Technology. Published by Elsevier Limited. All rights reserved.