Abstract:A single stage cryogenic liquid turbine is developed for replacing the Joule-Thompson valve and recovering energy from the liquefied air during throttling process in the large-scale internal compression air-separation unit, and evaluation of the impeller axial thrust at different conditions is essential for a reliable bearing design and stable operation. To predict the axial thrust load, a numerical model is established to simulate the turbine flow in a turbine stage environment, which includes the main flow domain (an asymmetrical volute, variable geometry nozzle, impeller, and diffuser), impeller front and back side gaps, and shaft seal leakage. Numerical simulation of flow is conducted by using the ANSYS-CFX. Flow characteristics in both main flow domain and impeller side gaps of the turbine stage are captured and analyzed. The axial thrust is then calculated based on the obtained pressure data in the impeller and its front and side gaps by using a direct integration approach.Flow behaviour in both main flow domain and impeller side gaps has been well exhibited by the numerical results. At the impeller back side gap inlet, the back flow is encountered even for design condition and it returns the impeller main flow stream; the impeller side gap flow has much influence on the axial thrust. To investigate influence of turbine operation condition on axial thrust, flow simulation is conducted at different mass flow rates and inlet pressure for the turbine stage, based on which the axial thrust is calculated. It is demonstrated from the obtained numerical results that the axial thrust increases as the inlet pressure increases and decreases as turbine flow rate increases. Geometry parametric study is conducted for the shaft seal clearances, which has demonstrated that the axial thrust is influenced largely by the clearance size and it decreases as the clearance grows.For the purpose of comparison, the empirical method is also used to predict the axial thrust load. The obtained results are compared to the numerical ones and evident deviation of the empirical from the numerical exists and the reason is that axial force components caused by the impeller main flow stream and its side gap flow are approximated very roughly in the empirical method.

Drag Prediction Method of Powered-on Civil Aircraft Based on Thrust Drag Bookkeeping

A Thrust Drag Bookkeeping Method Based on Computational Fluid Dynamics

Thrust-drag bookkeeping method of turbo-fan engine and its application

Drag Reduction Via Turbulent Boundary Layer Flow Control

DRAG PREDICTION AND REDUCTION FOR CIVIL TRANSPORTATION AIRCRAFT

Research on the Key Technology of Propulsion Drag System Division and Performance Analysis of Turboprop-powered Aircraft

Numerical Investigations of Outer-Layer Turbulent Boundary Layer Control for Drag Reduction Through Micro Fluidic-Jet Actuators

Interference Effect of Engine Exhaust on Civil Aircraft Drag Performance

An Investigation of Internal Drag Correction Methodology for Wind Tunnel Test Data in a High-Speed Air-Breathing Vehicle Using Numerical Analysis

Deep Learning Based Fast Prediction and Optimization of Aerodynamic Performance for a Propeller with Gurney Flap

Nacelle Aerodynamic Optimization and Inlet Compatibility

Drag Reduction by Laminar Flow Control

On the concept and theory of induced drag for viscous and incompressible steady flow

Aerodynamics of aero-engine installation

Reduced-dimensional Prediction Method for the Axial Aerodynamic Forces in the Off-Design Operation of Near-Critical CO2 Centrifugal Compressors

Prediction of Axial Thrust Load Acting on a Cryogenic Liquid Turbine Impeller

Design point analysis of the turbofan-driven turboelectric distributed propulsion system with boundary layer ingestion

Precise Drag Prediction of Airfoil Flows by a New Algebraic Model

Conjugate Heat Transfer Numerical Validation and PSE Analysis of Transonic Internally-Cooled Turbine Cascade

An adaptive integration method for hybrid-dimensional simulations of aeroengine flight statuses by incorporating computational fluid dynamics models of turbomachinery subcomponents

Decomposition of the mean friction drag on a NACA4412 airfoil under uniform blowing/suction