Abstract:Bimetallic catalysts are of great interest because they often display properties that differ from either of their parent metals. Previous studies on the Ni/Pt(111) bimetallic system have shown that the location of Ni atoms in the Pt(111) surface has a strong influence on the electronic and chemical properites of the surface [1]. The bimetallic surface consisting of a monolayer of Ni on top of bulk Pt(111), designated Ni-Pt-Pt(111), binds hydrogen and alkenes much more strongly than either parent metal, resulting in decreased hydrogenation activity. In contrast the surface consisting of a monolayer of Ni atoms in the subsurface region designated as Pt-Ni-Pt(111), has been shown to weaken metal-hydrogen bonds in comparison to Ni-Pt-Pt(111) or either parent metal surface. The resulting abundance of weakly bound hydrogen and alkenes on the Pt-Ni-Pt(111) surface increases its activity for novel low temperature hydrogenation pathways [2, 3]. In a previous attempt to extend these single crystal surface science studies to supported catalysts, PtCo bimetallic catalysts were found to be more active to hydrogenation reactions than PtNi bimetallic catalysts [4]. Therefore this study will focus on PtCo catalysts and the effect of different support materials on catalyst structure and activity. Co and Pt monometallic and PtCo bimetallic catalysts were synthesized and supported on γ-Al 2O 3, SiO 2, TiO 2, and activated carbon (AC). Temperature programmed reduction (TPR) studies were performed to characterize the reduction behavior of the catalysts and to identify suitable reduction conditions. CO chemisorption was used to determine the number of active sites on each catalyst. Flow reactor studies of benzene hydrogenation the series of catalysts were used to compare the activity of PtCo on the different supports. Normalizing the hydrogenation activity with the number of active sites yielded the following trend in activity: SiO 2 → Al 2O 3 → TiO 2 ∼ AC. Activation barriers were also calculated and followed a trend consistent with the normalized activity trend, that is: SiO 2 < Al 2O 3 < TiO 2 ∼ AC. Extended X-ray absorption fine structure (EXAFS) spectroscopy was used to characterize the extent of bimetallic formation. EXAFS analysis found that the SiO 2 and Al 2O 3 supported catalysts showed a greater extent of bimetallic formation (larger Pt-Co coordination number) than either the TiO 2 or AC supported catalysts. Both the TiO 2 and AC supported catalysts possessed large Pt-Pt coordination numbers, suggesting the presence of larger particles. Transmission electron microscopy (TEM) was utilized to characterize the particle sizes. Particles on the SiO 2 supported catalyst appeared to be the smallest and most dispersed, while larger particles were observed in both the TiO 2 and AC supported catalysts.

Ni–Co–Cu Supported on Pseudoboehmite-Derived Al2O3: Highly Efficient Catalysts for the Hydrogenation of Organic Functional Groups

Effective Hydrogen Production from Partial Oxidation of Propane over Composite Ni/Al2O3-SiC Catalyst

NiO x -promoted Cu-based catalysts supported on AlSBA-15 for chemoselective hydrogenation of nitroarenes

Nanostructured Ni-MoCx: An efficient non-noble metal catalyst for the chemoselective hydrogenation of nitroaromatics

Support effect on the low-temperature hydrogenation of benzene over PtCo bimetallic catalysts

Hydrogen or synthesis gas production via the partial oxidation of methane over supported nickel–cobalt catalysts

Superfine CoNi Alloy Embedded in Al2O3 Nanosheets for Efficient Tandem Catalytic Reduction of Nitroaromatic Compounds by Ammonia Borane

Ternary Cobalt–Copper–Niobium Catalysts for the Selective CO Hydrogenation to Higher Alcohols

Effective Ensemble of Pt Single Atoms and Clusters over the (Ni,Co)(OH) 2 Substrate Catalyzes Highly Selective, Efficient, and Stable Hydrogenation Reactions

Hcp-Phased Ni Nanoparticles with Generic Catalytic Hydrogenation Activities Toward Different Functional Groups

Highly Efficient and Chemoselective Tandem Hydroformylation‐Hydrogenation of Alkenes to Alcohols over g‐CN Supported Bimetallic Rh and Co Nanoparticles Catalysts

CoOx@Co Nanoparticle‐based Catalyst for Efficient Selective Transfer Hydrogenation of Α,β‐unsaturated Aldehydes

Ni-Based Hydrotalcite (HT)-Derived Cu Catalysts for Catalytic Conversion of Bioethanol to Butanol

NiCu Nanoparticles for Catalytic Hydrogenation of Biomass-Derived Carbonyl Compounds

Aqueous Phase Hydrodeoxygenation of Phenol on Hβ Zeolite Supported NiCo Alloy Catalysts

Co-presence of hydrophilic and hydrophobic sites in Ni/biochar catalyst for enhancing the hydrogenation activity

The Promoted Catalytic Hydrogenation Performance of Bimetallic Ni-Co-B Noncrystalline Alloy Nanotubes

Low temperature hydrogenation of benzene and cyclohexene: A comparative study between γ-Al2O3 supported PtCo and PtNi bimetallic catalysts

Two-Step, Oxygen-Free Conversion of Methane over Supported NiB Amorphous Alloy Catalysts

Elucidating the structure-activity relationship of the bimetallic Ni-Cu catalysts for CO 2 hydrogenation

Carbon-coated Ni-Co alloy catalysts: preparation and performance for in-situ aqueous phase hydrodeoxygenation of methyl palmitate to hydrocarbons using methanol as the hydrogen donor