Heating Strategy for Waste PCB Disassembly Oriented to the Reuse of Disassembled Components

LONG Danfeng,XIANG Dong,ZHANG Yongkai,DUAN Guanghong

DOI: https://doi.org/10.3901/jme.2014.17.124

2014-01-01

Journal of Mechanical Engineering

Abstract:Disassembling end-of-life printed circuit boards (PCBs) and reusing the high-value electronic components is an effective way of recycling. During the disassembly process, the quality of components is easily to reduce if the process is inappropriate. A common defect which usually arises in the disassembly process is interfacial delamination within plastic-encapsulated integrated circuits (ICs). The IC delamination is mainly caused by excessive high temperature. Therefore, research of the temperature field of the PCB and the heating strategy is necessary. A peak-temperature principle and a ramp-rate principle are proposed to meet the purpose of heating, i.e. melting the solder sufficiently and avoiding the IC delamination. The peak-temperature principle requires the peak temperature of the PCB should be as low as possible on the premise of melting the solder sufficiently;the ramp-rate principle requires that the ramp-up should be fast at first, and slow when the temperature is approaching the peak temperature. Then a thermal model of PCB heated in multiple temperature zones successively with hot air is built. Combined with this model, a heating strategy is proposed based on the temperature-field uniformity to achieve the temperature profile which conforms to the two heating principles. An experiment is conducted using an independently-developed disassembly machine for end-of-life PCBs to validate the heating strategy. The experimental results show:The PCB temperature field with the fast-then-slow (FTS) ramp from the heating strategy is more uniform than the temperature field with the ramp-to-spike (RTS) which is usually used in reflow process; their component disassembly rate is very close to each other; compared with the RTS ramp, the delamination fraction caused by the disassembly process is 80%lower with the FTS ramp;and thus the proposed heating strategy can effectively reduce IC delamination during the disassembly process.