Abstract:Atom probe tomography data is composed of a list of coordinates of the reconstructed atoms in the probed volume. The elemental identity of each atom is derived from time-of-flight mass spectrometry, with no local energetic or chemical information readily available within the mass spectrum. Here, we used a new data processing technique referred to as field evaporation energy loss spectroscopy (FEELS), which analyses the tails of mass peaks. FEELS was used to extract critical energetic parameters that characterize the field evaporation process, which are related to the binding energy of atoms to the surface under intense electrostatic field and dependent of the path followed by the departing atoms during the field evaporation process. We focused our study on different pure face centered cubic metals (Al, Ni, Rh). We demonstrate that the energetic parameters extracted from mass spectra can be mapped in 2D with nanometric resolution. A dependence on the considered crystallographic planes is observed, with sets of planes of low Miller indices showing a lower sensitivity to the intensity of the electric field, which indicates a lower effective attachment energy. The temperature is also an important parameter in particular for Al, which we attribute to an energetic transition between two paths of field evaporation between 25K and 60K close to (002) pole at the specimen's surface. This paper shows that the complex information that can be retrieved from the measured energy loss of surface atoms is important both instrumentally and fundamentally.

Parameters of the secondary electron yield from metal

Secondary electron emission from insulators and negative electron affinity semiconductors

Relation of Incident Energy of High Energy Primary Electron and Real Efficient Secondary Electron Emission Coefficient of Metal Emitter

Relation Between the Incident Angle of High Energy Primary Electron of Metal and the Real Efficient Emission Coefficient of Secondary Electron

Review of Metallic Microprotrusion Model and Microdielectrics Model in Vacuum

The secondary electron emission coefficient of disordered surfaces

Dynamic secondary electron emission in rough composite materials

The Dose Effect in Secondary Electron Emission

Prediction of the Cohesion Energy, Shear Modulus and Hardness of Single-Phase Metals and High-Entropy Alloys

Secondary electron spectrum of metals with different surface potential barriers

Editors' Choice—The Butler-Volmer Equation Revisited: Effect of Metal Work Function on Electron Transfer Kinetics

Reflection of H+(2 keV) Ions from Metallic Surfaces: Transport Theory Calculation of the Reflection Probability with the Mean Energy Approximation

Influence of the Method of Calculating the Effective Atomic Number on the Estimate of Fluorescence Yield for Metal Alloys of Biomedical Interest

Secondary electron emission and photoelectric emission with account of excited electrons' moving backward emission surface

Constraints on phase stability, defect energies, and elastic constants of metals described by EAM-type potentials

The chemical potential and the work function of a metal film on a dielectric substrate

Effect of rectangular grooves and checkerboard patterns on the electron emission yield

Crystallographic dependence of Field Evaporation Energy Barrier in metals using Field Evaporation Energy Loss Spectroscopy mapping

The Effect of Magnetic Field on the Secondary Electron Yield in the Ultra-High Vacuum Environment

Methodology for determining the electronic thermal conductivity of metals via direct non-equilibrium ab initio molecular dynamics

Α-Decay Half-Life Screened by Electrons