Abstract:Hardness, activation volume and strain-rate sensitivity of Cu/Cr (face-centered cubic (fcc)/body-centered cubic) and Cu/Zr (fcc/hexagonal close-packed) nanostructured multilayer films have been systematically measured as a function of modulation period (L) and modulation ratio (η), respectively. Significant size effects were found for all the three plastic deformation characteristics, i.e. enhanced hardness and activation volume but reduced strain-rate sensitivity with decreasing the dimension length L. Microstructure evolution was statistically examined to rationalize these size dependences. It was crucially observed that abundant nanotwins existed in the Cu grains, though nanotwin formation was depressed with smaller L. This inverse size-dependent nanotwin formation is responsible for the reduction in strain-rate sensitivity, because the negative effect induced by the decreased nanotwins predominates over the positive effect coming from the raised interfaces/boundaries. A mechanistic model is modified to account for the interface effect as well as the nanotwin effect, which yields calculations of strain-rate sensitivity in broad agreement with the experimental results when L is larger than about 20nm. Below this critical length size, there are discrepancies between the calculations and the experimental results, due to the change in deformation mechanism from dislocation nucleation/slip in confined layers to dislocation crossing interfaces. A confined layer slip model is also modified by considering the nanotwin strengthening to quantitatively describe the L-dependent hardness. In addition, the effects of constituent phases and their relative content on the activation volume and strain-rate sensitivity of NMFs are discussed with regard to variation in η.

Plastic Deformation Characteristics of Cu/X (X=cu-Zr, Zr) Nanolayered Materials

Deformation-induced Interfacial Transition Zone in Cu/V Nanolamellar Multilayers

Crystallization-aided extraordinary plastic deformation in nanolayered crystalline Cu/amorphous Cu-Zr micropillars

Role of Interfacial Transition Zones in the Fracture of Cu/V Nanolamellar Multilayers

Size-Dependent Deformation Mechanisms and Strain-Rate Sensitivity in Nanostructured Cu/X (X = Cr, Zr) Multilayer Films

Plastic Deformation Mechanisms and Size Effect of Cu50Zr50/Cu Amorphous/crystalline Nanolaminate: A Molecular Dynamics Study

Transition from Homogeneous-Like to Shear-Band Deformation in Nanolayered Crystalline Cu/amorphous Cu–Zr Micropillars: Intrinsic Vs. Extrinsic Size Effect

Plastic Deformation Behaviors of Amorphous-Cu50zr50/crystalline-cu Nanolaminated Structures by Molecular Dynamics Simulations

Intrinsic and extrinsic size effects on deformation in nanolayered Cu/Zr micropillars: From bulk-like to small-volume materials behavior

Plastic Deformation Modes of CuZr/Cu Multilayers

Length-scale-dependent Deformation and Fracture Behavior of Cu/X (x=nb, Zr) Multilayers: the Constraining Effects of the Ductile Phase on the Brittle Phase

Plastic Deformation Behaviours of CuZr Amorphous/crystalline Nanolaminate: a Molecular Dynamics Study

Comparisons Between Homogeneous Boundaries and Heterophase Interfaces in Plastic Deformation: Nanostructured Cu Micropillars Vs. Nanolayered Cu-based Micropillars

Effects of size and amorphous layer structure on the strength and plasticity of Cu/CuZr nanolaminates

Length scale-dependent deformation behavior of nanolayered Cu/Zr micropillars

Intrinsic size-controlled strain hardening behavior of nanolayered Cu/Zr micropillars

A New Deformation Mechanism of Amorphous/amorphous Laminates at Deep Nanoscale

Thickness-Dependent Strain Rate Sensitivity of Nanolayers Via the Nanoindentation Technique

Unusual Strain Rate Sensitivity of Nanoscale Amorphous Cuzr/Crystalline Cu Multilayers

Size- and constituent-dependent deformation mechanisms and strain rate sensitivity in nanolaminated crystalline Cu/amorphous Cu–Zr films

Ultra-high Strength and Plasticity Mediated by Partial Dislocations and Defect Networks: Part I: Texture Effect