Abstract:The ternary polymerization strategy of incorporating different donor and acceptor units forming terpolymers as photovoltaic materials has been proven advantageous in improving power conversion efficiencies (PCEs) of polymer solar cells (PSCs). Herein, a series of low band gap nonconjugated terpolymer acceptors based on two different fused-ring electron-deficient building blocks (IDIC16 and ITIC) with adjustable photoelectric properties were developed. As the third component, ITIC building blocks with a larger π-conjugation structure, shorter solubilizing side chains, and red-shifted absorption spectrum were incorporated into an IDIC16-based nonconjugated copolymer acceptor PF1-TS4, which built up the terpolymers with two conjugated building blocks linked by flexible thioalkyl chain-thiophene segments. With the increasing ITIC content, terpolymers show gradually broadened absorption spectra and slightly down-shifted lowest unoccupied molecular orbital levels. The active layer based on terpolymer PF1-TS4-60 with a 60% ITIC unit presents more balanced hole and electron mobilities, higher photoluminescence quenching efficiency, and improved morphology compared to those based on PF1-TS4. In all-polymer solar cells (all-PSCs), PF1-TS4-60, matched with a wide band gap polymer donor PM6, achieved a similar open-circuit voltage (Voc) of 0.99 V, a dramatically increased short-circuit current density (Jsc) of 15.30 mA cm–2, and fill factor (FF) of 61.4% compared to PF1-TS4 (Voc = 0.99 V, Jsc = 11.21 mA cm–2, and FF = 55.6%). As a result, the PF1-TS4-60-based all-PSCs achieved a PCE of 9.31%, which is ∼50% higher than the PF1-TS4-based ones (6.17%). The results demonstrate a promising approach to develop high-performance nonconjugated terpolymer acceptors for efficient all-PSCs by means of ternary polymerization using two different A–D–A-structured fused-ring electron-deficient building blocks.This article has not yet been cited by other publications.

Synthesis of all-conjugated donor–acceptor block copolymers and their application in all-polymer solar cells

Acceptor–acceptor conjugated copolymers based on perylenediimide and benzothiadiazole for all‐polymer solar cells

A conjugated donor-acceptor block copolymer enables over 11% efficiency for single-component polymer solar cells

Design and Synthesis of Novel Block Copolymers for Efficient Optoelectronic Applications

Dithienothiapyran: an Excellent Donor Block for Building High-Performance Copolymers in Nonfullerene Polymer Solar Cells.

Development of New Conjugated Polymers with Donor-Pi-Bridge-Acceptor Side Chains for High Performance Solar Cells

Conjugated Donor–Acceptor Terpolymers Toward High‐Efficiency Polymer Solar Cells

Conjugated rod-coil and rod-rod block copolymers for photovoltaic applications

Synthesis and Characterization of a Novel -D-B-A-B- Block Copolymer System for Potential Light Harvesting Applications

Block Copolymers for Optoelectronics

Synthesis and photophysical properties of N-alkyl dithieno[3,2- b:2',3'- d]pyrrole based donor/acceptor-π-conjugated copolymers for solar-cell application

All-polymer Solar Cells: Materials and Devices

Multi-Block Copolymers for Opto-electronics

A Novel Complementary Absorbing Donor–acceptor Pair in Block Copolymers Based on Single Material Organic Photovoltaics

Block copolymers as efficient cathode interlayer materials for organic solar cells

Improved synthesis and photovoltaic performance of donor–acceptor copolymers based on dibenzothiophene-cored ladder-type heptacyclic units

Direct Arylation Polymerization Toward Efficient Synthesis of Benzo[1,2-C:4,5-C '] Dithiophene-4,8-dione Based Donor-Acceptor Alternating Copolymers for Organic Optoelectronic Applications

Recent Development of Push–pull Conjugated Polymers for Bulk-Heterojunction Photovoltaics: Rational Design and Fine Tailoring of Molecular Structures

Nonconjugated Terpolymer Acceptors with Two Different Fused-Ring Electron-Deficient Building Blocks for Efficient All-Polymer Solar Cells

Ternary Donor-Insulator-acceptor Systems for Polymer Solar Cells.

Review on the Recent Progress in Low Band Gap Conjugated Polymers for Bulk Hetero‐junction Polymer Solar Cells