Abstract:The amplitude and phase imbalances of the in-phase (I) and quadrature (Q) branches inherent in the direct conversion receiver structure cause the generation of image frequency interference signals. In this paper, a frequency-domain I/Q imbalance calibration algorithm is proposed for wideband direct conversion receivers. The I/Q imbalance model is rebuilt by applying the infinitesimal method and FFT algorithm. The mathematical expressions for the exact computation of the I/Q imbalance parameters are derived based on the frequency-domain statistical properties of the baseband signal. The two phase parameters, frequency-dependent I/Q imbalance (FD-IQI) and frequency-independent I/Q imbalance (FI-IQI), are separated according to the parity properties of the imbalance parameter. To avoid the interference from the transmitter, the receiver impairment estimation is performed using a frequency offset (FO) DC training signal, and a low-cost real-valued compensation (RVC) filter is introduced to correct the impairments of the received signal. The performances of the proposed calibration model are evaluated through simulations and experiments. The simulation results show that the image rejection ratio (IRR) is improved to 80-120 dBc and can also exceed 40 dBc at high noise levels. The experimental results based on the CX9261A evaluation board show that the average IRR of the multi-tone signal is increased by 24.99 dB, and the IRR of the wideband signal is increased by 19.08 dB.

Model Calibration of Non-Ideal Lowpass Filter in Modulated Wideband Converter for Compressive Sampling

A New Compensating Method of Non-Ideal Lowpass Filters in Modulated Wideband Converter

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

A Blind Calibration Model for I/Q Imbalances of Wideband Zero-IF Receivers

Modeling of a 14-bit, 100-MS/s pipelined ADC with digital nonlinearity calibration

Successive-phase Correction Calibration Method for Modulated Wideband Converter System

A Calibration System and Perturbation Analysis for the Modulated Wideband Converter

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

Digitally Assisted IIP2 Calibration for CMOS Direct-Conversion Receivers

Model-Based Calibration of Filter Imperfections in the Random Demodulator for Compressive Sensing

Modeling of a 200 KHz Bandwidth Low-pass Switch-capacitor Sigma-delta DAC with a Raised Spur-free Modulator

Analysis and Signal Recovery of Modulated Wideband Converter with Gain Mismatch

MMIC on-Wafer Test Method Based on Hybrid Balanced and Unbalanced RF Pad Structures

Calibration of Analog to Information Converter based Sampling System

A Digital Calibration Technique for an Ultra High-Speed Wide-Bandwidth Folding and Interpolating Analog-to-digital Converter in 0.18μm CMOS Technology

Low-Complexity Calibration Of Joint Tx/Rx I/Q Imbalance In Wideband Direct-Conversion Transceiver

Sub-Nyquist sampling reconstruction algorithm based on SVD and MUSIC

Adaptive Digital Calibration Techniques for Narrow Band Low-If Receivers with On-Chip Pll

A Digital Demodulation Method for Amplitude Modulated Signal Based on Sub-Nyquist Sampling

Analysis of Non-Idealities of Low-Pass Filter in Random Demodulator

Model-Based Multichannel Compressive Sampling with Ultra-Low Sampling Rate