Abstract:The multicore fiber amplifier, as a key component in spatial division multiplexing (SDM) communication systems, presents higher technical difficulty compared to traditional multi-channel single core fiber amplifiers, which has sparked widespread attention. To achieve balance, efficiency, miniaturization, and cost-effectiveness in the performance of multi-core optical fiber amplifiers, we propose an innovative triple cladding 13-core Er/Yb co-doped microstructured fiber (13CEYDMOF). The proposed fiber features an outer cladding with peanut-shaped air holes, which enables uniform excitation of the 13 cores using a single multimode laser pump source within the inner cladding. This approach also prevents damage or aging of the fiber's outer coating due to the pump laser. Furthermore, the design of Peanut-Shaped Air Holes effectively increases the numerical aperture (NA) of the inner cladding while reducing the outer diameter of the fiber, enhancing the fiber's mechanical flexibility. To address the coupling difficulties caused by air holes, we bi-directionally pump the 13CEYDMOFA by utilizing a combined technique of the side winding and end pumping. The experimental results show that the 13CEYDMOFA can achieve an average gain of 23.8 dB, a noise figure (NF) of ∼4.6 dB, and an inter-core gain difference of less than 2 dB in the wavelength range of 1529–1565 nm. The in-line amplified transmission experiment demonstrates that the 13CEYDMOFA is well suited for the 13 spatial channels transmission. To the best of our knowledge, this is the first time to realize high performance telecommunication band amplification in a multicore microstructure fiber.

Numerical Analysis of Mode Competition and Selection in Yb-doped Multicore Fiber Lasers

Numerical Modeling Of Transverse Mode Competition In Strongly Pumped Multimode Fiber Lasers And Amplifiers

Theoretical Modelling of Single-Mode Lasing in Microcavity Lasers Via Optical Interference Injection.

Effect of mode competition on photodarkening distribution of Yb-doped fiber laser

Theoretical and experimental study on transverse mode competition in a partial-coiled multimode fiber laser

Investigations on Transverse-Mode Competition and Beam Quality Modeling in End-Pumped Lasers

Transverse Mode Switchable Fiber Laser with a Multimodal Interference-Based Beam Shaper

Mode Competition Analysis in Dual-Wavelength Coupled-Cavity Semiconductor Laser

Study of mode propagation with 632.8-nm laser in tapered fiber

Transverse mode propagation studies in a thulium-doped fiber laser

Integration of an anti-resonant hollow-core fiber with a multimode Yb-doped fiber for high power near-diffraction-limited laser operation

Influence of Mode Competition on Beam Quality of Fiber Amplifier

Single-mode Annular Chirally-Coupled Core Fibers for Fiber Lasers

Spatiotemporal mode-locking in multimode fiber lasers

Fiber laser longitudinal mode selection using common resonant cavity

Design of Solid-Core Bragg Few-Mode Fiber for Short-Reach MDM Networks in O+C+L Band

Numerical Analysis of Temperature Distributions in Yb-Doped Double-Clad Fiber Lasers with Consideration of Radiative Heat Transfer

A novel multicore Er/Yb co-doped microstructured optical fiber amplifier with peanut-shaped air holes cladding

Novel constant-cladding tapered-core ytterbium-doped fiber for high-power fiber laser oscillator

Anticrossings induced by index depressions and their impact on mode area scaling of active large pitch fibers

Dynamic modal characteristics of transverse mode instabilities in ytterbium-doped fiber laser oscillator