Abstract:A comprehensive three-dimensional model of droplet-gas two-phase flow is presented to examine the evolution of spray along the downstream of the exit orifice in an effervescent atomizer. For gas phase, the Navier-Stokes equations with k-epsilon turbulence model are solved, considering two-way coupling of the interaction between droplets and the gas phase. The dispersed droplet phase is modeled as Lagrangian entities, accounting for the physical phenomena of droplet generation from primary and secondary breakup, droplet collision and coalescence, droplet momentum, and heat transfer. This model is used to calculate the mean size and statistical distributions of atomized droplets under various operating conditions such as air-to-liquid ratio (ALR), injection pressure, liquid flow rate, nozzle exit diameter, and liquid material. The simulation results compare well with the experimental data, with an accuracy of 5% for the atomizer operated under annular flow conditions. Gas flow and spray evolution of the droplets are predicted; effects of operating conditions on the droplet mean size and distributions are discussed. Results show that ALR is one of the most important control parameters. Increasing ALR will decrease the droplet size gradually and finally tend to a certain limitation. A decreasing nozzle exit favors primary breakup, while high injection pressure has more influence on the secondary atomization. An increasing liquid mass flow rate has better primary breakup and worse overall atomization downstream. The liquid properties also have great impact on the droplet atomization. The less the viscosity and surface tension, the easier liquid breaks into smaller drops.

Three-dimensional Numerical Simulation of Droplet Deposition

Numerical Simulation of Liquid Drop Deposition in Annular-Mist Flow Regime of Boiling Water Reactor

Simulation of drop deposition process in annular mist flow using three-dimensional particle method

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Computational Analysis of Splash Occurring in the Deposition Process in Annular-Mist Flow

Three-Dimensional Simulation Of Effervescent Atomization Spray

Numerical Simulation of the Collision Behaviors of Binary Unequal-Sized Droplets at High Weber Number

Numerical Simulations of Droplet Impact Onto a Pool Surface

Numerical Simulation for Two-Dimensional Surface Wave Structure of a Vertical Liquid Falling Film

Simulation of Droplet-gas Flow in the Effervescent Atomization Spray with an Impinging Plate

Numerical Simulation of Drops Falling to and Splashing on Liquid Interfaces

Impact and boiling characteristics of a droplet on heated surfaces: A 3D lattice Boltzmann study

Two-dimensional numerical simulation of hydrodynamic behaviors of drop covered with vapor film

Numerical Simulation of Droplet Impact Onto Liquid Films with Smoothed Particle Hydrodynamics

Numerical Simulation of a Single Drop Impact on Liquid Surface using Particle Method

Numerical investigation of droplet impact on heated surfaces with pillars

Numerical Simulation on Falling Film Behavior

Numerical Simulation of Droplet Impact on Textured Surfaces in a Hybrid State

Numerical Simulation of Droplet Oblique Impact on Liquid Film with Moving Particle Semi-Implicit Method

Simulation on a three-dimensional collision of a moving droplet against a moving super-hydrophobic particle

Numerical Simulation of Micron and Submicron Droplets in Jet Impinging