Abstract:Recently there has been significant interest in the field of molecular resists as a route to shrinking the trade-off between resolution, line width roughness and sensitivity for next generation lithography. We have previously presented initial results of a three component fullerene derivative based negative tone chemically amplified electron beam resist with sparse feature resolution of ~12 nm, half pitch resolution of ~20 nm, sub 5 nm line width roughness, sub 10 μC/cm2 sensitivity, and high etch durability. Here we present a further study of the properties of this molecular resist. The material shows extremely wide process latitude. In particular it has been shown that the resolution and sensitivity of the resist are not strongly affected by the post exposure bake conditions. Indeed a post exposure bake was not required at all in order to observe high resolution high sensitivity behavior from the material implying that this is a low activation energy resist. Such low Ea resists were original developed to address problems with airborne contaminants (T-topping) but can suffer from problems with extended post exposure delay (acid diffusion) and with sensitivity to humidity. However, the fullerene based resist was extremely stable under ambient conditions and for post exposure delays of 24 hours, regardless of whether a post exposure bake was applied, showing that the post exposure bake step can be eliminated for this resist, and furthermore that the chemical amplification reaction in the material is in some way self limiting.

Chemically Amplified Phenolic Fullerene Electron Beam Resist

Chemically Amplified Molecular Resists for E-Beam Lithography

Chemically Amplified Fullerene Resists for E-Beam Lithography

A Chemically Amplified Fullerene-Derivative Molecular Electron-Beam Resist

A High Resolution Water Soluble Fullerene Molecular Resist for Electron Beam Lithography

Chemical Amplification of a Triphenylene Molecular Electron Beam Resist

Low Activation Energy Fullerene Molecular Resist

Fullerene Resist Materials for the 32 Nm Node and Beyond

Performance of a high resolution chemically amplified electron beam resist at various beam energies

Chemically Amplified Fullerene Resists, Spin-on Fullerene Hardmasks and High Aspect Ratio Etching

Fullerene Derivatives as Novel Resist Materials for Fabrication of MEMS Devices by Electron Beam Lithography

Highly Sensitive Cationic Photoresist for High-Throughput Two-Photon Nanofabrication

Functionalization of Fullerene for Electron Beam Nanolithography Resist.

A Fullerene Derivative As an Electron Beam Resist for Nanolithography

Positive-tone Chemically Amplified Fullerene Resist

New High Resolution Liquid Crystal Electron Beam Resists

Ultrathin Fullerene Films As High-Resolution Molecular Resists for Low-Voltage Electron-Beam Lithography.

10 Nm Scale Electron Beam Lithography Using a Triphenylene Derivative As a Negative/positive Tone Resist

Towards 11nm Half-Pitch Resolution for a Negative-Tone Chemically Amplified Molecular Resist Platform for Extreme-Ultraviolet Lithography

Optimization of Fullerene-Based Negative Tone Chemically Amplified Fullerene Resist for Extreme Ultraviolet Lithography

CO2‐Based Dual‐Tone Resists for Electron Beam Lithography