Abstract:Local area networks (LANs) are becoming popular in industrial computercontrolled systems increasingly. Broadcast LANs aimed at the interconnection of sensors, actuators and controllers are commonly known as fieldbus networks. Recently, the vendor-specific fieldbus has being substituted by vendor-independent standardized fieldbus, which supports the open system concept and has started to be used commonly. Particular relevance must be given to the IEC 61158 (1999), which encompasses eight widely used fieldbuses: FF HI, ControlNet, PROFIBUS, P-NET, FF HSE, SwiftNet, WorldFIP and Interbu (Xiuju 2000; Xiong 2000) known that time constraints are more stringent as we go down in the automation hierarchy. In this charter, we consider time constraints or deadlines as the maximum allowable time span between a message transfer request and its transmission on the bus. In fact, the total message cycle delay results from multiple factors, such as the access and queuing delays, the transmission time (frame length / transmission rate) and the protocol processing time. As we are dealing with realtime communication across a shared transmission medium, we focus our analysis on the access delay and queuing delay factors. These factors depend on the MAC (Medium Access Control) mechanism used by the fieldbus network. Fieldbus, as infrastructure of communication to support real-time traffic among field devices in factory floor, is one of typical real-time network. According to real-time application, protocol of MAC layer of fieldbus can be divided into event-triggered and time-triggered. The former does not support the real-time application directly and usually uses CSMA (Carrier Sense Multiple Access), like CAN and LON. The latter supports the real-time application directly and often uses token. Further, the time-triggered can be sub-divided into three classes: 1) centralized token in WorldFIP and Foundation Fieldbus; 2) distributed token in PROFIBUS and FDDI; 3) virtual token in P-Net. Recently, several studies on the ability of fieldbus networks to cope with realtime requirements have been presented, such as those by Tindell and Zuberi on

An Overview and Comparison of Time-Triggered Protocols for X-By-Wire Applications

A time‐triggered control network for industrial automation

Time Triggered CAN and Its Application to Distributed Vehicle Network

Deterministic Intra-Vehicle Communications: Timing and Synchronization

Design and Test of Hardware-in-the-loop Platform for Vehicle Chassis CAN System with Intermittent Open and Short Connection Faults

Research and realization of control network for agriculture and forestry machinery based on CAN

A Survey on Time-Sensitive Networking Standards and Applications for Intelligent Driving

Online Real-Time Estimation of Response Time for Periodic Messages in Controller Area Networks

Design for Control Handle of Electric Trucks Based on CAN Bus

Integrated safety critical systems on reliable real time network

Deterministic Communications for In-vehicle Network: Overview and Challenges.

A Network Interface Device for Networked Control System with Time-Driven Mode

CAN Application-layer Protocol Design of Intelligent Monitoring System for Cotton-picking Machine

Intrusion detection and defence for CAN bus through frequency anomaly analysis and arbitration mechanism

Application Layer Definition and Analyses of Controller Area Network Bus for Wire Harness Assembly Machine

Real-time Communication Using Foundation Fieldbus

Technical Application of Controller Area Network on Hybrid Electrical Vehicle

Design and Analysis of Multi-Node CAN Bus for Diesel Hybrid Electric Vehicle

Design and development of an extensible multi-protocol automotive gateway

Development Of Field Control System Of Automated Guided Vehicle Based On Wireless Local Area Network And Can Bus

Modelling and Simulation of TTCAN for Hybrid Electric Vehicles Based on CANoe