Abstract:In this study, ozone catalysts (hydrogenation-modified red mud, HM-RM) successfully prepared by hydrogenation-modification of industrial hazardous solid waste red mud (RM) as a raw material in accordance with the viewpoint of treating waste with waste and using waste. Meanwhile, as for the common phenomenon of membrane fouling, uneven distribution of multiphase solid catalysts and ozone in liquids, the addition of ultrasound can not only disperse materials, but also play a role in online cleaning of ceramic membranes and catalysts. The optimum treatment conditions for Rhodamine B (RhB) solution with volume of 2 L and concentration of 40 mg/L were catalyst concentration of 0.4 mg/L, reaction temperature of 45 °C, ultrasonic time of 1 h, ultrasonic intensity of 600 W, removal rate of RhB was up to 90 %. In addition, the computational fluid dynamics (CFD) simulation method was used to investigate the fluid flow between the two gas-liquid phases and the effect of the negative pressure of the membrane pump on the fluid by the analysis of flow, pressure and ozone flux of the ceramic membrane(CM) reaction apparatus. The CFD simulation results showed that at the inlet gas-liquid flow rate of 3 m/s and the negative pressure of 20,000 Pa, the maximum flow rates of CM-1 were 3 m/s, 0.752 m/s for CM-2, and 0.228 m/s for CM-3, respectively. Vortices, which are beneficial to solid-liquid mixing and gas-liquid mass transfer, formed between the suction port CM-1 of CM-1 and the inlets of CM-2 and CM-3. This discovery is consistent with relevant experimental research results. Significantly higher concentrations of both •OH and dissolved ozone were observed in the US/HM-RM/O3 system compared to other systems, indicating the significant improvement in ozone utilization rate through the application of ultrasound. The superiority of the US/HM-RM/O3 device was demonstrated. The real dye effluent was tested under optimum operating conditions and the results showed that COD and TOC were reduced by 81.34 % and 60.23 % respectively after 180 min of treatment. The above research can provide technical support for the treatment of dye wastewater using Ultrasound-enhanced ozone oxidation ceramic membranes.

COMBINED USE OF ULTRASOUND AND OZONE FOR BIOFOULING CONTROL IN HEAT EXCHANGERS

The Mechanism and Application of the Combination of Ultrasonic Irradiation and Ozone in Water Treatment

Coagulation and oxidation for controlling ultrafiltration membrane fouling in drinking water treatment: Application of ozone at low dose in submerged membrane tank

Synergistic Effect of Ozone and Non-Oxidizing Bacteriostatic Agent on Biofouling Control of Reverse Osmosis Membranes

Beneficial role of pre- and post-ozonation in a low rate biofiltration-ultrafiltration process treating reclaimed water

Control ultrafiltration membrane fouling in Chlorella-laden water treatment by integrated heat-activated peroxydisulfate pre-oxidation and coagulation treatment

Effect of Chemical Preoxidation Coupled with In-Line Coagulation As a Pretreatment to Ultrafiltration for Algae Fouling Control

Synergistic process using calcium peroxide and ferrous iron for enhanced ultrafiltration of Microcystis aeruginosa-laden water

In vitro and in silico approaches to investigate antimicrobial and biofilm removal efficacies of combined ultrasonic and mild thermal treatment against Pseudomonas fluorescens

Controlling ultrafiltration membrane fouling in surface water treatment via combined pretreatment of O3 and PAC: Mechanism investigation on impacts of technological sequence

Enhanced Mass Transfer of Ozone and Emerging Pollutants through a Gas-Solid-Liquid Reaction Interface for Efficient Water Decontamination

Applying permanganate/bisulfite (PM/BS) pre-oxidation enhanced coagulation to control fouling of ultrafiltration membrane in drinking waterworks

Continuous ultrasonic ozone coupling technology-assisted control of ceramic membrane fouling coupled enhanced multiphase mixing to treat dye wastewater and CFD flow field simulation

Effect of In-Situ Ozonation on Ceramic UF Membrane Fouling Mitigation in Algal-Rich Water Treatment

Development of Biofouling by Bacillus Subtilis on Heat Transfer Surfaces in the Presence of Silica Dioxide Particles

Integrated Ferrate and Calcium Sulfite to Treat Algae-Laden Water for Controlling Ultrafiltration Membrane Fouling: High-efficiency Oxidation and Simultaneous Cell Integrity Maintaining

Membrane Fouling and Rejection of Organics During Algae-Laden Water Treatment Using Ultrafiltration: A Comparison Between in Situ Pretreatment with Fe(II)/Persulfate and Ozone

Biofouling Control Using Periodic H 2 O 2 Cleaning with CuO Modi fi ed and Polypropylene Spacers

Coupling in-situ ozonation with ferric chloride addition for ceramic ultrafiltration membrane fouling mitigation in wastewater treatment: Quantitative fouling analysis

Effect of pretreatment by permanganate/chlorine on algae fouling control for ultrafiltration (UF) membrane system

Effect of the coupling modes on EfOM degradation and fouling mitigation in ozonation-ceramic membrane filtration