Abstract:In this study, we examined the thermal effects throughout the process of the placement of span-scale girder segments on a 6×110-m continuous steel box girder in the Hong Kong-Zhuhai-Macao Bridge. Firstly, when a span-scale girder segment is temporarily stored in the open air, temperature gradients will significantly increase the maximum reaction force on temporary supports and cause local buckling at the bottom of the girder segment. Secondly, due to the temperature difference of the girder segments before and after girth-welding, some residual thermal deflections will appear on the girder segments because the boundary conditions of the structure are changed by the girth-welding. Thirdly, the thermal expansion and thermal bending of girder segments will cause movement and rotation of bearings, which must be considered in setting bearings. We propose control measures for these problems based on finite element method simulation with field-measured temperatures. The local buckling during open-air storage can be avoided by reasonably determining the appropriate positions of temporary supports using analysis of overall and local stresses. The residual thermal deflections can be overcome by performing girth-welding during a period when the vertical temperature difference of the girder is within 1 °C, such as after 22:00. Some formulas are proposed to determine the pre-set distances for bearings, in which the movement and rotation of the bearings due to dead loads and thermal loads are considered. Finally, the feasibility of these control measures in the placement of span-scale girder segments on a real continuous girder was verified: no local buckling was observed during open-air storage; the residual thermal deflections after girth-welding were controlled within 5 mm and the residual pre-set distances of bearings when the whole continuous girder reached its design state were controlled within 20 mm.

Displacement Monitoring and Analysis of Expansion Joints of Long-Span Steel Bridges with Viscous Dampers

Dynamical Behavior of Steel Box Girder Bridges Due to Vehicle-Induced Vibration at Expansion Joint

Control Measures for Thermal Effects During Placement of Span-Scale Girder Segments on Continuous Steel Box Girder Bridges

Response and Vibration Control of Steel Box-girder Bridge When Vehicles Passing through the Expansion Joint

SHM-based condition assessment of expansion Joints in suspension Bridges

Failure Mechanism of Expansion Joints in a Suspension Bridge

Incorporating Site-Specific Weigh-in-motion Data into Fatigue Life Assessment of Expansion Joints under Dynamic Vehicle Load

Stochastic Seismic Response Analysis of Long-span Continuous Rigid Frame Bridge

Strain-Based Structural Condition Assessment of an Instrumented Arch Bridge Using Fbg Monitoring Data

Condition Assessment of Expansion Joint of a Cable-Stayed Bridge Based on Long-Term Monitoring

An analysis method of vehicle–bridge coupling vibration considering effects of expansion joint parameters and its application

The Seismic Response Of Long Span Continuous Rigid Frame Box Girder Bridges Subjected To Spatially Varying Ground Motions

Damage Detection for Expansion Joints of a Combined Highway and Railway Bridge Based on Long-Term Monitoring Data

Performance evaluation of cable-stayed bridge expansion joints based on Lasso dimensionality reduction and temperature-displacement-correlation model

Damage alarming for bridge expansion joints using novelty detection technique based on long-term monitoring data

Research on Mapping Relationship Between Environmental Load and Vibration Response of Bridge Structure Based on Structural Health Monitoring Data

Development of Steel Dampers for Bridges to Allow Large Displacement Through a Vertical Free Mechanism

Shaking table test study on the seismic control of concrete-filled steel tube arch bridges based on dampers

Development of Steel Dampers for Bridges

Research on the longitudinal movement and influence of restraint parameters of the long-span suspension bridge’s main girder