Sintering Process And Its Mechanism Of Mgb2 Superconductors

Zongqing Ma,Yongchang Liu
DOI: https://doi.org/10.5772/33794
2012-01-01
Abstract:The superconductivity at 39 K discovered in MgB2 among simple binary chemical composition attracted much interest in its fabrication techniques and practical applications [1]. MgB2 superconductor exhibits many impressive properties such as highest critical temperature amongst intermetallic superconductors which means low cooling costs, impressive grain boundary transparency to the flow of current which leads to greater critical current density [24], comparatively large coherence length which allows a better Josephson junction fabrication, low material cost which will lead to a cheaper superconductor technology, simple crystal structure, etc. Hence, MgB2 superconductors, especially the MgB2 wires and coils, have the outstanding potential to be integrated into diverse commercial applications, such as, magnetic resonance imaging (MRI) [5, 6] , fault current limiters (FCL), Josephson junctions and SQUID [7, 8, 9], transformers, motors, generators, adiabatic demagnetization refrigerators, magnetic separators, magnetic levitation applications, energy storage, and high energy physical applications. But the MgB2 itself is mechanically hard and brittle and therefore not amenable to drawing into the desired wire and tape geometry. Thus, the powder-in-tube (PIT) technique that was used to make the Y-Ba-Cu-O oxide superconductor has been employed in the fabrication of MgB2 wires and tapes these years [10-14]. So far, in-situ sintering, including the in-situ PIT, from the mixture of magnesium and boron is the major method to fabricate MgB2 superconductors (bulks, wires and tapes). The corresponding sintering parameters have a significant influence on the superconducting properties of MgB2. Thus it is necessary to investigate the sintering mechanism of MgB2 superconductors.
What problem does this paper attempt to address?