Research on Ti-48%Al-2%Cr-2%Nb Automobile Exhaust Valve Cast by Centrifugal Casting Process in Permanent Mold

盛文斌,李东,杨锐,郭景杰,刘羽寅,苏彦庆,贾均

DOI: https://doi.org/10.3321/j.issn:1001-4977.2001.03.003

2001-01-01

Abstract:In this paper, Ti-48Al-2Cr-2Nb automobile exhaust valve was castby the centrifugal casting method in permanent mold and its surface layer structure, microstructure, element distribution , mechanical properties etc were analyzed by SEM, XRD and EMPA . Furthermore, the valves treated by HIP were tested on 483Q diesel engine platform. Results showed that the distribution of alloying elements in Ti-Al based alloy for exhaust valve was uniform and its microstructure was refined to a certain extent. The mechanical properties of exhaust valve cast by centrifugal permanent mold then treated by HIP were that the σb = 670MPa, σ0.2 =527.5MPa and δ=3%. Result of the engine platform test showed that the valve had excellent air-tightness and wear-resistant properties, so could successfully satisfy requirements of the engine.