Abstract:The attractiveness of direct water injection advantages has made a comeback in the minds of designers due to the potential knock mitigation and lower NO x emissions. The current work established and validated an appropriate 3D model for hydrogen-enriched Wankel engines with direct water injection, and the used CFD simulation was mainly a consideration of combustion and flow phenomena inside the engine and securing the gained knowledge. The determinations of the knock operation and position were investigated, and the intrinsic mechanism of end-gas auto-ignition was clarified. Then, the effects of water injection strategies on knock mitigation and NO x reduction were analyzed in detail. Results showed that the end-gas auto-ignition caused the drastic variation of the local velocity field and the severe pressure oscillation in the vicinity of these regions, which led to knocking combustion. The highest knock propensity occurred at the trailing part of the recess, especially on the opposite side of the intake port. The pressure oscillation of water-enriched schemes was smaller than water-free schemes, and the knock intensity gradually decreased with the advance of water injection timing. When the injection timing was 250°EA, the propensity of end-gas auto-ignition was weakened obviously due to the reduced local temperature and pressure within the rotor chamber, and NO x formation was lower than the other schemes. The local pressure fluctuation was decreased by increasing water addition, whose maximum decrement occurred at the trailing part of the recess. The knock intensity gradually decreased as the amount of water injection increased. When the water injection ratio of 40%, there was no obvious auto-ignition occurrence, and NO x formation reduced significantly at the exhaust moment, which confirmed direct water injection was one of the most promising and effective methods to control knock propensity and NO x emissions simultaneously. In addition, the water droplets of a smaller water injection ratio (10%) scheme spread faster than the water-free scheme after spontaneous combustion, which could reach the fuel surface to present azeotropic phenomena and then enhance the combustion. This result shall give insights into the feasibility of a proper water addition for improving the thermal efficiency of the Wankel engine regime.

Significant NOx Reductions with Direct Water Injection into the Sub-Chamber of an IDI Diesel Engine

Effect of direct water injection on combustion and emissions characteristics of marine diesel engines

Effect of water injection into the intake manifold on combustion and NO x emissions of CHP engine fuelled with natural gas

Exploring the Benefits of Hydrogen-Water Injection Technology in Internal Combustion Engines: A Rigorous Experimental Study

The Effect of Water Injection on a Naturally Aspirated Spark-Ignited Engine

Investigation of water spray evolution process of port water injection and its effect on engine performance

An insight into direct water injection applied on the hydrogen-enriched rotary engine

Simultaneous Reductions in Diesel NOx and Smoke Emissions with Aqueous Metal-Salt Solutions Directly Injected into the Combustion Chamber

Numerical Investigations of Injection Timing Effects on a GDI Engine Performance: Part B, In-Cylinder Emission Formation and Oxidation Process

Effect of Water Injection on Combustion and Emissions Parameters of SI Engine Fuelled by Hydrogen–Natural Gas Blends

Numerical Investigation of the Effect of Injection Timing on the In-Cylinder Activity of a Gasoline Direct Injection Engine

Effect of Post-Injection on Combustion and Exhaust Emissions in DI Diesel Engine

Experimental research of direct water injection characteristics over wide range of injection temperature and ambient pressure

Effects of direct water injection timings on knock suppression, combustion, and emission performance of high compression ratio hydrogen-enriched natural gas engine

Experimental study on the effect of water port injection on the combustion and emission characteristics of diesel/methane dual-fuel engines

Effects of coupling port water injection and EGR on the spray water evolution, combustion and emission of a premixed stoichiometric natural gas engine: A numerical study

Experimental investigation of water injection and spark timing effects on combustion and emissions of a hybrid hydrogen-gasoline engine

Research and Development of Self-Contained Water Injection Systems

Thermal efficiency improvement of super-lean burn spark ignition engine by stratified water insulation on piston top surface

Water injection strategies to control gas temperatures in hydrogen–air internal combustion engines

Experimental Investigation of Homogeneous Charge Induced Ignition (hcii) with Low-Pressure Injection to Reduce Pm Emissions in A Heavy-Duty Engine