Abstract:: Despite signi ﬁ cant advances in double-crystalline coil − coil block copolymers (BCPs), investigations into double-crystalline all-conjugated rod − rod BCPs have been comparatively fewer and are limited in scope. Moreover, the ability to control the crystalline structures of all-conjugated BCPs may endow the materials and devices with enhanced optoelectronic properties over the two respective constituents. Herein, we report the synthesis of a series of poly(3-hexylthiophene)- block -poly(3-butylselenophene) (P3HT- b -P3BS) BCPs with tunable block ratios and investigate the e ﬀ ects of block ratio and thermal annealing process on their crystallization and microphase-separated structures. These rod − rod BCPs exhibit a sole P3HT crystallization (P3HT/P3BS = 63:37) or individual P3HT and P3BS crystallization (P3HT/P3BS = 55:45 and 42:58) in as-cast thin ﬁ lms, in ﬂ uenced by the block ratio of P3HT/P3BS. Interestingly, upon 200 ° C-annealing (i.e., annealed at the temperature below the melting points of P3HT and P3BS form I blocks), P3HT- b -P3BS (P3HT/P3BS = 63:37) remains the sole P3HT crystallization, while P3HT- b -P3BS (P3HT/ P3BS = 55:45 and 42:58) transforms from two individual P3HT and P3BS crystal domains into cocrystals, accompanied by the phase transition of P3BS block from form II to I. Remarkably, after a higher thermal annealing at 230 ° C (i.e., close to the melting point of P3HT block yet below the melting point of P3BS form I block), the cocrystalline structures originally existing in P3HT- b P3BS (P3HT/P3BS = 55:45 and 42:58) at the 200 ° C-annealing process do not form, and they reverse back to individual P3HT and P3BS form I crystals. Finally, the relationship between various structures of P3HT- b -P3BS and the resulting charge mobilities is clari ﬁ ed. This study provides an insight into the interplay between microphase separation of P3HT- b -P3BS and crystallization of both P3HT and P3BS blocks tailored by the block ratio and thermal annealing temperature and correlates their di ﬀ erent structures with the charge transport properties. high-resolution pattern. Di ﬀ erential scanning calorimetry (DSC) was measured using a TA DSC Q2000 at a heating rate of 10 ° C/min under N 2 ﬂ ow. UV − vis absorption spectra were recorded on PerkinElmer Lambda 750 UV − vis spectropho-tometers. Cyclic Voltammetry (CV) curves were obtained using a CHI 660 Electrochemical Analyzer with a degassed acetonitrile solution of tetrabutylammonium hexa ﬂ uorophosphate (Bu 4 NPF 6 , 0.1 M). Atomic force microscopy (AFM) images were obtained using a Bruker Dimension FastScan in the tapping mode. The samples for AFM measurement were prepared by spin-coating the polymer solutions (10 mg/mL) on silicon wafers at 2000 r/min for 20 s. The charge transport properties of OFETs were measured using a Keithley 4200-SCS in an argon- ﬁ lled glovebox.

Phase Separation in Poly(Alkylthiophene): Pcbm Bulk Heterojunctions Probed with Morphology, Optical Response and Aggregates Size

Understanding the Phase Separation Evolution in Efficient P3ht: Ic(70)Ba-Based Bulk-Heterojunction Polymer Solar Cells

Quantitative characterization of phase separation in the photoactive layer of polymer solar cells by the phase image of atomic force microscopy

The Near Surface Morphology of P3HT:PCBM Blend Films Studied by Near-Edge X-Ray Absorption Fine Structure

Impact of Side‐chain Length on the Phase Structures of P3ATs and P3AT:PCBM Films As Revealed by SSNMR and FTIR

Composition-dependent Phase Separation Effects of Organic Solar Cells Using P3HT:PCBM As Active Layer and Chromium Oxide As Hole Transporting Layer

Annealing-induced Phase Separation in Small-Molecular Bulk Heterojunctions

The Broken out and Confinement Phase Separation Structure Evolution with the Solution Aggregation and Relative Crystallization Degree in P3HT/N2200

The Effect of Thermal Treatment on the Morphology and Charge Carrier Dynamics in A Polythiophene-Fullerene Bulk Heterojunction

Thermally Induced Vertical Phase Separation and Photovoltaic Characteristics of Polymer Solar Cells for P3ht/Pcbm Composites

Improving the Morphology of Pcdtbt:Pc70bm Bulk Heterojunction by Mixed-Solvent Vapor-Assisted Imprinting: Inhibiting Intercalation, Optimizing Vertical Phase Separation, and Enhancing Photon Absorption

Solution Processing Dependent Bulk Heterojunction Nanomorphology of P3HT/PCBM Thin Films.

Molecular Orientation and Phase Separation by Controlling Chain Segment and Molecule Movement in P3HT/N2200 Blends

Solvent vapor-induced self assembly and its influence on optoelectronic conversion of poly(3-nexylthiophene): Methanofullerene bulk heterojunction photovoltaic cells

Temperature-dependent morphology evolution of P3HT:PCBM blend solar cells during annealing processes

Effects of a heavy atom on molecular order and morphology in conjugated polymer:fullerene photovoltaic blend thin films and devices

Annealing Of P3ht:Pcbm Blend Film-The Effect On Its Optical Properties

Unravelling the Correlation Between Microphase Separation and Cocrystallization in Thiophene-Selenophene Block Copolymers for Organic Field-Effect Transistors

A Phase Diagram of the P3ht:Pcbm Organic Photovoltaic System: Implications for Device Processing and Performance

The Formation of Crystalline P3HT Fibrils Upon Annealing of a PCBM:P3HT Bulk Heterojunction

Rapid Phase Segregation of P3HT:PCBM Composites by Thermal Annealing for High-Performance Bulk-Heterojunction Solar Cells