Abstract:Si is emerging as one of the most prospective anode materials for all-solid-state Li-ion batteries due to its extremely high theoretical capacity density of 4200 mAh g -1 and relatively negative potential for lithiation/delithiation. Towards its widespread use, controlling severe volume expansion/contraction during lithiation/delithiation is a challenge because it may cause cracking, fracture, and pulverization that negatively influence the cycle performance and rate capability of the cells [1]. Such mechanical event is induced by the change in the lattice structure due to the formation of Li x Si and successive increasing/decreasing of Li content x in Li x Si [2]. Bimodal atomic force microscopy (AFM) offers quantitative mapping of nanoscale mechanical property, simultaneously with surface topography imaging [3]. Our group previously applied this technique to the cross-section of a composite electrode consist of active materials, binders, conductive additives, and deposited electrolyte solution and successfully demonstrated nanomechanical mapping [4]. Here, we develop an operando bimodal AFM system to track Young’s modulus changes of electrode materials in an all-solid-state battery configuration during the lithiation and delithiation reactions in real-time. A cell in a Cu/Si/LLZT/In/Li configuration was fabricated as follows; a 3 μm-thick Si thin-film and a 100 nm-thick Cu layer were sputter-deposited on one side of Li 6.6 La 3 Zr 1.6 Ta 0.4 O 12 (LLZT) solid electrolyte, an In layer was sputter-deposited on the other side of LLZT, the Cu/Si/LLZT/In sample was milled with an Ar-ion beam to yield a flat and smooth cross-section suitable for AFM analysis, and then a 50 μm-thick Li metal foil was combined with the pre-coated In thin layer. Operando nanomechanical mapping was performed by mounting the cross-section-exposed cell in the custom-made sample holder coupled with a potentiostat for bias applications, in an Ar-filled glove box to prevent any atmospheric influences. Electrochemical lithiation and delithiation were carried out within a potential window of 0.01-1.20 V vs. Li/Li + . Electrochemical characterization indicated that the capacities of the Si electrode for the first lithiation and delithiation are 3300 and 1833 mAh g -1 , respectively. These capacities are equal to the formation of Li 3.46 Si after the first lithiation of the pristine Si and Li 1.54 Si after the successive delithiation from Li 3.46 Si. Throughout the lithiation, the averaged Young’s modulus of Si electrode decreased due to the formation of Li x Si and increase in the Li content x in Li x Si. In the initial stage of lithiation, it drastically decreased because Li x Si was formed by the lithiation of pristine Si. Then, it moderately decreased with increasing Li content x in Li x Si. Unfortunately, the Young’s modulus maps were only recorded until the formation of Li 1.54 Si because the successive delithiation was not completed possibly due to the phase transformation of crystalline Li x Si to amorphous Li x Si [5], which may cause a significant mechanical strain inside the thin film. The measured Young’s modulus values were consistent with those obtained by first principle calculation [6]. Further details are given at the presentation. References: J. Zhong, T. Wang, L. Wang, L. Peng, S. Fu, M. Zhang, J. Cao, X. Xu, J. Liang, H. Fei, X. Duan, B. Lu, Y. Wang, J. Zhu and X. Duan, Nano-Micro Letters , 14 , 50 (2022). M. T. McDowell, S. W. Lee, W. D. Nix and Y. Cui, Advanced Materials , 25 , 4966 (2013). M. Kocun, A. Labuda, W. Meinhold, I. Revenko and R. Proksch, ACS Nano , 11 , 10097 (2017). H. Sakai, Y. Taniguchi, K. Uosaki and T. Masuda, Journal of Power Sources , 413 , 29 (2019). R. Endo, T. Ohnishi, K. Takada and T. Masuda, The Journal of Physical Chemistry Letters , 13 , 7363 (2022). H. Kim, C.-Y. Chou, J. G. Ekerdt and G. S. Hwang, The Journal of Physical Chemistry C , 115 , 2514 (2011).

Investigation on Si Anode Materials for Lithium-Ion Batteries Using X-ray Absorption Spectroscopy

Lithiation of Silicon Anode based on Soft X-ray Emission Spectroscopy: A Theoretical Study

Advanced Inorganic Lithium Metasilicate Binder for High-Performance Silicon Anode.

Shedding X-ray Light on the Interfacial Electrochemistry of Silicon Anodes for Li-Ion Batteries.

In Situ Formation of Ionically Conductive Nanointerphase on Si Particles for Stable Battery Anode

Investigation of a Porous NiSi2/Si Composite Anode Material Used for Lithium-Ion Batteries by X-ray Absorption Spectroscopy

Adapting Simultaneous in Operando Electrochemical Quartz Crystal Microbalance (EQCM) and Electrochemical Impedance Spectroscopy (EIS) to Studies of SEI Layer Formation on Amorphous Silicon Anodes

Lifetime Optimization of Amorphous Silicon Thin-Film Anodes for Lithium-Ion Batteries

Probing the Reactivity of the Active Material of a Li-Ion Silicon Anode with Common Battery Solvents

Engineering Si-Based Anode Materials with Homogeneous Distribution of SiO x and Carbon for Lithium-Ion Batteries

Rational Design and Performance of Ansode Materials Based on Si/SiO x /C Particles Anchored on Graphene Sheets

In Situ TEM Investigation of Congruent Phase Transition and Structural Evolution of Nanostructured Silicon/Carbon Anode for Lithium Ion Batteries

Operando Nanomechanical Mapping of Silicon Thin Film Electrode during the First Lithiation and Delithiation Investigated By Bimodal Atomic Force Microscopy

In situ Scanning Electron Microscopy of Silicon Anode Reactions in Lithium-Ion Batteries during Charge/Discharge Processes

Mechanical Properties and Chemical Reactivity of Li xSiO y Thin Films

Unraveling the Mechanism of Phase Transformation and Structural Evolution in Si Anode with Deep-Potential Molecular Dynamics

Long-cycle and High-rate Si/SiOx/Nitrogen-doped Carbon Composite as an Anode Material for Lithium-ion Batteries

Probing Surface Dynamics of SiO x Thin-Film Electrodes during Cycling through X-Ray Photoemission Spectroscopy and Operando X-Ray Reflectivity

Understanding Electrochemical Properties for a Bio-Based Silicon Anode Electrode Enhanced with Carbon Nanostructure Conductive Additives and Water-Based Binders

SiOx embedded in N-doped carbon nanoslices: A scalable synthesis of high-performance anode material for lithium-ion batteries

(Digital Presentation) Operando X-Ray CT Analysis of Silicon-Solid Electrolyte Mechanical Interface of All-Solid-State Battery