Abstract:The operation reliability of the power grid and the stability of social production are seriously threatened by the icing of the overhead line. The equivalent ice thickness (EIT) is to convert different densities and shapes of ice into the uniform annular ice with density of 0.9 g/cm 3 . Although many methods for calculating EIT of transmission line conductors have been proposed, there are lack an effective monitoring method of EIT for 500 kV ground wire with tangent tower under the special terrain where "the virtual lowest point" of the ground wire appears in the condition of large height difference. Therefore, a calculation method of EIT for 500 kV ground wire with tangent tower under the special terrain based on vertical tension measurement technology is proposed. That is the iterative method is used to preset different EITs. Then the calculated vertical tension under the preset values are solved by the established ground wire state equation and vertical tension equation. The EIT can be obtained when the calculated vertical tension is equal to the measured vertical tension. The comparison between the artificial observed EIT and the calculated EIT is carried out for two practical cases of 500 kV ground wire in the mountainous area of southern China. The results show that the absolute error is less than 2 mm, which verify the two values are in strong agreement. The corresponding finite element simulation models are established. A comparative study between the simulated EIT and the calculated EIT is carried out. The results show that the relative error is less than ±10% under severe icing from 10 mm to 30 mm and the absolute error is less than 1 mm under mild icing of 5 mm, which verify the two values are highly consistent. Finally, the application effect of this method in practical cases is analyzed.

Ice Thickness Sensor for Overhead Transmission Lines Based on Capacitance Sensing

Icing Thickness Measuring Method with a Capacitance Sensor for Overhead Power Transmission Lines

A Contactless Conductivity Sensor Based on Capacitively Coupled Principle

Capacitively Coupled Contactless Conductivity Detection Based On Phase-Sensitive Demodulation Principle

Design and Implementation of an Industrial C4D Sensor for Conductivity Detection

Development of a Capacitive Ice Sensor to Measure Ice Growth in Real Time

Detection Method for Equivalent Ice Thickness of 500-kV Overhead Lines Based on Axial Tension Measurement and Its Application

The Detecting System and Method of Quasi-Distributed Fiber Bragg Grating for Overhead Transmission Line Conductor Ice and Composite Insulator Icing Load

De-Icing Strategies in Different Stages for Transmission Lines

A Measurement Method of Ice Layer Thickness Based on Resistance-Capacitance Circuit for Closed Loop External Melt Ice Storage Tank

Inversion of Transmission Line Icing State Based on Sag Monitoring

Non-contact surface water conductivity measurement system

The Quantitative Detection System and Method for Natural Ice Covering of Composite Insulators by Quasi-Distributed Fiber Bragg Gratings

Experimental Study on the Icing Dielectric Constant for the Capacitive Icing Sensor

Online sensing method for transmission line conductor ice cover based on fiber optic sensing information fusion and continuous wavelet decomposition

Experimental study on ice monitoring method for 10 kV transmission line with tangent tower in alpine landform

Ice monitoring of aluminum conductor steel-reinforced cables using guided waves

Capacitive Sensing of Icing under Vacuum and Cryogenic Temperatures

Icing detection method of 500 kV overhead ground wire with tangent tower under special terrain based on vertical tension measurement technology

A Novel Detection Algorithm for the Icing Status of Transmission Lines

CAPACITIVE SENSOR FOR SURFACE ICING CONTROL