Abstract:The operation reliability of the power grid and the stability of social production are seriously threatened by the icing of the overhead line. The equivalent ice thickness (EIT) is to convert different densities and shapes of ice into the uniform annular ice with density of 0.9 g/cm 3 . Although many methods for calculating EIT of transmission line conductors have been proposed, there are lack an effective monitoring method of EIT for 500 kV ground wire with tangent tower under the special terrain where "the virtual lowest point" of the ground wire appears in the condition of large height difference. Therefore, a calculation method of EIT for 500 kV ground wire with tangent tower under the special terrain based on vertical tension measurement technology is proposed. That is the iterative method is used to preset different EITs. Then the calculated vertical tension under the preset values are solved by the established ground wire state equation and vertical tension equation. The EIT can be obtained when the calculated vertical tension is equal to the measured vertical tension. The comparison between the artificial observed EIT and the calculated EIT is carried out for two practical cases of 500 kV ground wire in the mountainous area of southern China. The results show that the absolute error is less than 2 mm, which verify the two values are in strong agreement. The corresponding finite element simulation models are established. A comparative study between the simulated EIT and the calculated EIT is carried out. The results show that the relative error is less than ±10% under severe icing from 10 mm to 30 mm and the absolute error is less than 1 mm under mild icing of 5 mm, which verify the two values are highly consistent. Finally, the application effect of this method in practical cases is analyzed.

Inversion of Transmission Line Icing State Based on Sag Monitoring

Icing Thickness Measuring Method with a Capacitance Sensor for Overhead Power Transmission Lines

Sag Monitoring of Transmission Line Based on Motion Sensor

Icing detection method of 500 kV overhead ground wire with tangent tower under special terrain based on vertical tension measurement technology

Predictive Model for Equivalent Ice Thickness Load on Overhead Transmission Lines Based on Measured Insulator String Deviations

De-Icing Strategies in Different Stages for Transmission Lines

Simulation and analysis of induced voltage and induced current on overhead ground wire of Jindongnan-Nanyang-Jingmen 1000kV UHV AC transmission line

Numerical Simulation of Transmission LineIcing Based on Computational Fluid Dynamics

Experimental study on ice monitoring method for 10 kV transmission line with tangent tower in alpine landform

Review of On-line Monitoring System of Ice Coating on Transmission Lines

Detection Method for Equivalent Ice Thickness of 500-kV Overhead Lines Based on Axial Tension Measurement and Its Application

Numerical Simulation and Study of Icing Characteristics of High-speed Railway Catenary under Different Environmental Conditions

An Early Warning Method of Transmission Line Icing Based on Power Grid Meteorological Monitoring Data

Simulation Research on Suppression Measures Against Severe Ice-Shedding of Ultra-high Voltage Alternating Current Ultra-Long Span Transmission Lines

Linear modeling analysis of the heat balance of the transmission line in high frequency critical ice melting state

Whole process analysis for non-uniform ice shedding of transmission lines

A Review of Icing and Anti-Icing Technology for Transmission Lines

Current Reconstruction and Sag/Wind Deflection Monitoring of Transmission Lines by Magnetic Sensing

Risk assessment models of power transmission lines undergoing heavy ice at mountain zones based on numerical model and machine learning

Early Warning Model for Transmission Line Deicing Jumps Based on BP Neural Network

Development of Anti-Icing Coatings Applied to Insulators in China