Investigation of the Granule Loss of Poroelastic Road Surfaces Using the Aachener-Ravelling-Tester (Arte)

A. Schacht,D. Wang,B. Steinauer
2011-01-01
Bauingenieur
Abstract:The volume of heavy goods traffic on German roads is predicted to rise again considerably in the coming years along with an increase in environmental pollution through traffic. In particular the effects of exhaust fumes and noise on people will increase to a considerable extent. The effects of traffic noise on people are manifold. Street noise is not only annoying but can also be extremely injurious to health.Against this background intensive research has been carried out for some years into the reduction of noise emissions caused by road traffic. This research concentrates mainly on the reduction of tyre/road noise by means of noise-reducing road surfaces. In addition to the known approach to noise reduction through open-pored road surfaces (noise reduction is about 5-8 dB(A)), so-called poroelastic road surfaces (PERS) have been developed in recent years. These are road surfaces which are manufactured using rubber granules, sand and a polyurethane binder. According to 001 a poroelastic road surface is an upper layer which displays not only a very high void content (> 20 Vol.%) but also substantial elasticity due to the use of rubber granules. This results in a marked decrease of road noise and in particular a considerable reduction of noise emissions of 10 to 12 dB (A) in the contact areas tyres/road.What can be seen as problematic however is the resistance of poroelastic road surfaces to shear load. Particularly in turn-off areas and bends and through sudden starting and sharp braking processes strong shear forces occur which result in granule breakout on the road surface.This investigation focused in particular on the problem of granule loss in turn-off areas and bends. In order to carry out the tests four variants of a poroelastic road surface were designed and put under load with the Aachener-Ravelling-Tester (ARTe). This enabled a practical simulation of granule loss in turn-off areas and bends caused by tire load.After periods of 5, 10, 20 and 40 minutes the granule loss of the four variants was recorded and then evaluated according to their composition using correlation and regression analyses. On the basis of the gained test results an attempt is to be undertaken to optimize the composition of poroelastic road surfaces with regard to resistance to granule loss and if necessary a composition will be recommended with a view to use in practice.
What problem does this paper attempt to address?