Abstract:In this study, the dual supercritical phases were proposed and employed to facilitate the synthesis of dimethyl carbonate (DMC) from CO2 and methanol, which may improve the diffusion rate and contact opportunities of reactant molecules. Under the novel reaction conditions, the synthesis temperature was higher than the supercritical temperatures of each reactant (> 239 degrees C), and the partial pressure for each reactant constituent was larger than its partial supercritical pressure (p(CO2) > 7.4 MPa & P-methanol > 8.1 MPa), respectively. A series of YxFe1- xO delta-T catalysts with perovskite-structure were applied in the dual supercritical phases, whose surface properties, crystal phase, microstructure, acidic-basic amounts, and the concentration of oxygen vacancies were detected by BET, XRD, SEM, NH3/CO2-TPD, XPS and EPR, respectively. It was evident from the characterization results that the Y0.5Fe0.5O delta-850 catalyst possessed the largest acidic-basic amounts, which enabled its highest catalytic activity. The experimental results revealed that higher DMC yield could be achieved under the novel dual supercritical phases (240 degrees C, 16 MPa), and the increased DMC yield without stirring in the autoclave can be obtained in an impressive shorter reaction time of 3 h, surpassing it acquired at the regular synthesis time of 9 h with stirring during the reaction.

Selective synthesis of dimethyl carbonate from urea and methanol over Fe2O3/HMCM-49

Highly selective synthesis of dimethyl carbonate from urea and methanol catalyzed by ionic liquids

Kinetics studies of dimethyl carbonate synthesis from urea and methanol over ZnO catalyst

A Composite Fe–V/g-C3N4 for Liquid-Phase Selective Oxidation of Methanol with O2 Oxidant

Influence of preparation conditions on catalytic properties of iron oxide for synthesis of dimethyl carbonate

Preparation and Catalytic Performance of Fe-Zr-O Catalysts for Direct Synthesis of Dimethyl Carbonate Using CO2 and Methanol

Direct Synthesis of Dimethyl Ether on Supported Cu-Mn Catalysts

Synthesis of Methyl Acetate by Dimethyl Ether Carbonylation over Cu/HMOR: Effect of Catalyst Preparation Method

Synthesis of Dimethylcarbonate from Urea and Methanol Catalyzed by Various Metal Oxides and Salts

Highly Active and Selective Cu/Sio2 Catalysts Prepared by the Urea Hydrolysis Method in Dimethyl Oxalate Hydrogenation

Mechanism and catalytic performance for direct dimethyl ether synthesis by CO2 hydrogenation over CuZnZr/ferrierite hybrid catalyst

K‐doped CuO/ZnO with dual active centers of synergism for highly efficient dimethyl carbonate synthesis

Direct synthesis of dimethyl carbonate from CO<sub>2</sub> and methanol in dual supercritical phases over Y<sub>x</sub>Fe<sub>1-x</sub>O<sub></sub> catalysts

Novel Fe‐modified CeO2 nanorod catalyst for the dimethyl carbonate formation from CO2 and methanol

Selective Hydrodeoxygenation of 5‐Hydroxymethylfurfural to 2,5‐Dimethylfuran over Heterogeneous Iron Catalysts

Selective hydrodeoxygenation of 5-hydromethylfurfural to 2,5-dimethylfuran over PtFe/C catalyst

Synthesis of Dimethyl Ether on Supported Cu-Mn Catalysts

Non‐oxidative conversion of methanol to dimethyl ether, methyl formate and dimethoxymethane over Cu/Hβ catalyst: Tailoring product selectivity

Advances in the Catalysts for Synthesis of Dimethyl Carbonate(dmc) by Direct Alcoholysis of Urea

Synthesis of Dimethyl Carbonate from Urea and Methanol Catalyzed by the Metallic Compounds at Atmospheric Pressure

Selective Catalytic Oxidation of 5-Hydroxymethylfurfural to Produce 2,5-Diformylfuran Over Nitrogen Doped Porous Carbons