Abstract:The goal of the ANAIS-112 experiment, which operates at LSC, is to test in a model independent way the DAMA/LIBRA positive signal using the same target (NaI(Tl) crystals) and technique. Several strategies have been followed in this work to improve the sensitivity of the ANAIS-112 experiment. The Quenching Factor (QF) is a key factor in the comparison between different experiments. It has been determined both for iodine and sodium nuclear recoils in 5 crystals, for the first time in the same setup and using the same analysis protocol. Compatible values have been obtained for all of them. The calibration method in electron equivalent energy has proved to be critical in the QF estimation and allows understanding the discrepancies between previous measurements, but not concluding if the sodium QF is constant with energy or it increases up to about 80 keVnr. Therefore, further work is required to understand the conversion of the energy deposited in NaI(Tl) into light by different particles, as it is essential to develop a model for the QF. As a first step in an effort to understand the origin of some of the spurious event populations observed in the experiment, a GEANT4 simulation of an ANAIS-112 module has been developed including optical light emission and propagation after an energy deposit. Finally, the possibility of improving the sensitivity of NaI scintillators by replacing Photomultiplier Tubes with Silicon Photomultipliers as light sensors has been studied. These detectors offer very interesting opportunities within the new project ANAIS+. In this work we have characterized SiPMs from different manufacturers, established measurement protocols for the most relevant parameters, studied the properties of NaI and NaI(Tl) crystals at different temperatures and designed NaI+SiPM prototypes that will allow us to evaluate the limitations and opportunities of this new technology.

Challenges of Fission Research at the Improved Igisol Facility

Ion counting efficiencies at the IGISOL facility

Accurate fission data for nuclear safety

A Hot Cavity Laser Ion Source at IGISOL

Production of clean rare isotope beams at TRIUMF Ion guide laser ion source

Instrumentation for correlated prompt $n$-$γ$ emission studies in coincidence with fission fragments

Recent Upgrades of the Gas Handling System for the Cryogenic Stopping Cell of the FRS Ion Catcher

A Comparison of RIST and ISOLDE Tantalum Targets and Geometries Used On-Line at ISOLDE

Voltage scanning and technical upgrades at the Collinear Resonance Ionization Spectroscopy experiment

Implementation of Design Changes Towards a More Reliable, Hands-off Magnetron Ion Source

PSFC / JA-1645 Kinetic studies of ICF implosions

Test System Upgrade for ITER Current Lead Series Production at ASIPP

An MeV Proton Irradiation Facility: DICE

Optimising the Collinear Resonance Ionisation Spectroscopy (CRIS) Experiment at CERN-ISOLDE

Instrument design for an inertial confinement fusion ion temperature imager

Designing an upgrade of the Medley setup for light-ion production and fission cross-section measurements

Kinetic Studies of ICF Implosions

New strategies to improve the sensitivity of the ANAIS-112 experiment at the Canfranc Underground Laboratory

Expanding RIB Capabilities at the Cyclotron Institute: \textsuperscript{3}He-LIG production with an Isobar Separator LSTAR

Overview of Recent Studies and Design Changes for the FNAL Magnetron Ion Source

Mitigation strategies for time-resolved x-ray diagnostic data degradation due to high neutron yield of ICF experiments at the NIF