Abstract:Particulate emissions from homogeneous charge compression ignition (HCCI)engines are often considered as negligible and the measurement of particulate matter (PM) with HCCI combustion systems has been rare. An earlier publication in the literature and the authors' own recently published work suggest that PM emissions from gasoline direct injection (DI) HCCI engines should not be neglected. It has been shown that PM emissions from HCCI engines, although generally lower, can be similar to spark ignition (SI) levels for certain engine conditions, especially in the accumulation mode. The present work shows that although injection timing is effective for control of HCCI, it can have a significant impact on PM emissions. Engine speed also appears to have an impact on PM emissions for the HCCI combustion mode. Typically for HCCI operating at 1500 r/min, the total mass and total number of the PM emissions could be up to six times higher when the fuel is injected during the recompression period compared with the case for injection during the inlet valve open period. Similarly, when the engine was operated in SI mode, an attempt to inject fuel close to induction top dead centre (TDC) made the PM emission noticeably higher, reaching unacceptable levels. The split injection strategy for HCCI mode has been investigated for its effect on PM emissions. It has been found that the PM. number concentration for split injection lies between the maximum concentration measured for very early injections (near TDC at recompression) and the minimum concentration measured for the latest injections used (at crank angles near to the inlet valve maximum opening time), with the magnitude of number density varying approximately from 0.2 to 1.2 million/cm(3). It is also observed that for split injection the number of particulates in nucleation mode varies less, while the number in accumulation mode level varies within a limit of one order of magnitude; both are dependent on the injection strategy. The shape of the PM distribution is such that the nucleation mode exceeds the number concentration of 1 x 10(7) (dN d log D-p) and the accumulation mode falls parabolically to approximately 1 x 10(6). For comparison, it can be said that the PM number concentration measured in the authors' engine is approximately one order of magnitude lower in accumulation mode than the level for a typical modern diesel engine.

Gc-Ms Speciation And Quantification Of 1,3 Butadiene And Other C1-C6 Hydrocarbons In Si/Hcci V6 Engine Exhaust

Numerical Investigation of Methane Number and Wobbe Index Effects in Lean-Burn Natural Gas Spark-Ignition Combustion

Formaldehyde, Acetaldehyde and Other Aldehyde Emissions from HCCI/SI Gasoline Engine Equipped with Prototype Catalyst

Effect of composite aftertreatment catalyst on alkane, alkene and monocyclic aromatic emissions from an HCCI/SI gasoline engine

Speciation of Hydrocarbon and Carbonyl Emissions of 2,5-Dimethylfuran Combustion in A Disi Engine

Control of Harmful Hydrocarbon Species in the Exhaust of Modern Advanced GDI Engines

Hc, Co and Nox Emissions Reduction Efficiency of A Prototype Catalyst in Gasoline Bi-Mode Si/Hcci Engine

Comparative Study On Gasoline Hcci And Dici Combustion In High Load Range With High Compression Ratio For Passenger Cars Application

Sequenced Combustion Characteristics, Emission and Thermal Efficiency in Gasoline Homogeneous Charge Induced Ignition

Modeling of HCCI combustion: From 0D to 3D

Effect Of Injection Timing On Gasoline Homogeneous Charge Compression Ignition Particulate Emissions

Influence of Inlet Air Temperature on Gasoline HCCI Particulate Emissions

Research on steady and transient performance of an HCCI engine with gasoline direct injection

Research on Emission Characteristics of Methanol-Gasoline Blend Direct Injection HCCI Combustion

Computational study of excess air ratio impacts on performances of a spark-ignition H 2 /methanol dual-injection engine

A computational study of direct injection gasoline HCCI engine with secondary injection

Study of Cycle Variation in a Multi-Cylinder Gasoline HCCI Engine

Mapping and Quantifying Isomer Sets of Hydrocarbons ( ≥ C12) in Diesel Exhaust, Lubricating Oil and Diesel Fuel Samples Using GC × GC-ToF-MS

Effects of spark ignition and stratified charge on gasoline HCCI combustion with direct injection

EMISSION CHARACTERISTICS OF STOICHIMETRIC SICI COMBUSTION

Numerical Simulation of HCCI Engine with Multi-Stage Gasoline Direct Injection Using 3D-CFD with Detailed Chemistry