Abstract:Purpose The three-axis simulator relies on the air film between the air bearing and the bearing seat to achieve weightlessness and the frictionless motion condition, which is essential for simulating the micro-disturbance torque of a satellite in outer space. However, at the beginning of the experiment, the disturbance torque caused by the misalignment between the center of gravity of the simulator and the center of rotation of the bearing is the most important factor restricting the use of the space three-axis simulator. In order to solve this problem, it is necessary to set the balance adjustment system on the simulator to compensate the disturbance torque caused by the eccentricity. The paper aims to discuss these issues. Design/methodology/approach In this paper, a study of L1 adaptive automatic balancing control method for micro satellite with motor without other actuators is proposed. L1 adaptive control algorithm adds the low-pass filter to the control law, which in a certain sense to reduce the high-frequency signal and speed up the response time of the controlled system. At the same time, by estimating the adaptive parameter uncertainty in object, the output error of the state predictor and the controlled object can be stabilized under Lyapunov condition, and the robustness of the system is also improved. The automatic balancing method of PID is also studied in this paper. Findings Through this automatic balancing mechanism, the gravity disturbance torque can be effectively reduced down to 10 −6 Nm, and the automatic balancing time can be controlled within 7 s. Originality/value This paper introduces an automatic balancing mechanism. The experimental results show that the mechanism can greatly improve the convergence speed while guaranteeing the control accuracy, and ensuring the feasibility of the large angle maneuver of spacecraft three-axis simulator.

Parameter Estimation of an Air-Bearing Suspended Test Table

A Novel Three-Parameter Tuning Method For Seismic Simulation Shaking Table

Levelling Control of an Electro-pneumatic Stabilized Platform Driven by Pneumatic Muscles

Research on the Modeling, Control, and Calibration Technology of a Tracked Vehicle Load Simulation Test Bench

Characterizing an Air-Bearing Testbed for Simulating Spacecraft Dynamics and Control

Experimental research for flexible satellite dynamic simulation on three-axis air-bearing table

Estimation of Vibration Characteristics of a Space Manipulator From Air Bearing Supported Test Data

Air bearing platforms for simulation of spacecraft attitude control systems

Research on Analysing and Compensation of the Steady Disturbing Torque of the Three Axis Air Bearing Table

Three-axis air-bearing based platform for small satellite attitude determination and control simulation

Dynamic modelling and parameter identification of a 3-DOF flight simulator platform

Dynamic Modeling and Analysis of a 3-DOF Ultra-precision Positioning Stage with Air Bearinga

A study of PID and L1 adaptive control for automatic balancing of a spacecraft three-axis simulator

IAC-15,E2,2,4,X31653 3-DOF GAS BEARING SIMULATOR FOR SMALL SATELLITE TESTS WITH AUTOMATED MASS DISPLACEMENT CONTROL TO ELIMINATE DISTURBANCE TORQUES

Research on the aerostatic rotary table for micro-gravity test based on micro-orifice throttling

The Way of Adjusting Balance for Single Axis Air Bear Table Based on Mathematical Modeling

Balancing of a Small Satellite Attitude Control Simlator on an Air Bearing

Parameter Estimation Based Angular Velocity Observer Design for Rigid-Body Spacecraft

The Analysis and Compensation of Elastic Unbalance Torque of the Three-axis Air-bearing Simulator

Development of air spindle and triaxial air bearing testbeds for spacecraft dynamics and control experiments

A Method for the Estimation of Oil Film Parameters in an Asymmetric Rotor-Bearing System