Experimental Study and Analysis on Double Effect Absorption Heat Pump for Efficient Waste Heat Recovery
Zhenyuan Xu,Hongcai Mao,Dianshou Liu,Ruzhu Wang
DOI: https://doi.org/10.1360/tb-2020-0150
2020-01-01
Chinese Science Bulletin (Chinese Version)
Abstract:A large amount of industrial energy consumption is dissipated as waste heat in China. In order to dissipate the waste heat efficiently, evaporative cooling is widely used, which induces energy waste, water waste and emission issues. Industrial waste heat recovery with heat pump is an effective solution for such problems, and is becoming more and more important under the strict emission control and energy consumption policy. Currently, the major technologies for waste heat recovering heat pump include single effect absorption heat pump and compression heat pump. However, low grade of driven energy and high efficiency are two conflicting factors, which cannot be satisfied at once. Single effect absorption heat pump is driven by low grade energy but its coefficient of performance (COP) is also low, while compression heat pump has high COP but also needs high grade energy as driven force. Currently, there is no technical compromise between single effect absorption heat pump and compression heat pump regarding the conflict between driven energy grade and efficiency, which is not enough for the ever growing need for waste heat recovery. To address these issues, double effect absorption heat pump is studied, which serves as a compromise between two popular heat pump technologies. Modeling and experimental studies are both carried out for the double effect LiBr-water absorption heat pump. Modeling results show that double effect LiBr-water absorption heat pump could get COP of 1.92 similar to 2.47, which is higher than the 1.48 similar to 1.81 COP of single effect absorption heat pump. However, high generation temperature of 139.5 similar to 190 degrees C is also necessary. Besides, the ratio of absorption heat output to overall heat output in double effect absorption heat pump is higher, which is beneficial to fit the external heat source with temperature glide and reduce the irreversible losses. This will increase the overall performance of double effect absorption heat pump for waste heat recovery. The theoretical study is followed by an experimental study of the double effect absorption heat pump. A double effect absorption heat pump unit with rated heating capacity of 3489 kW was designed, manufactured and tested. Testing results showed that the heat pump achieved heat output temperature of 68.08 degrees C, COP of 2.62 and heating output of 3517.20 kW when driven by 0.6 MPa steam and 36.17 degrees C waste hot water. As more technical options are available for waste heat recovering heat pump, their comparison to each other is also necessary to get the advantage and disadvantage. In this case, this paper further compared the single effect absorption heat pump, double effect absorption heat pump and compression heat pump under the scenario of waste heat recovery for domestic heating supply. Experimental results were used and multiple evaluating parameters including COP, exergy efficiency and exergy rate were analyzed, which shows the conclusions as follows. Absorption heat pumps have the lower COP but higher exergy efficiency than compression heat pump, due to the less internal irreversible loss. Double effect absorption heat pump has higher exergy rate than compression heat pump and higher COP than single effect absorption heat pump, which makes it superior for waste heat upgrading.