The Influence of Ethanol Blends on Particulate Matter Emissions from Gasoline Direct Injection Engines

Longfei Chen,Mike Braisher,Alison Crossley,Richard Stone,Dave Richardson

DOI: https://doi.org/10.4271/2010-01-0793

2010-01-01

Abstract:Particulate Matter (PM) legislation for gasoline en gines and the introduction of gasoline/ethanol blen ds, make it important to know the effect of fuel composition on PM emissions. Tests have been conducted with fuels of known composition in both a single cylinder engine and V8 engine with a three-way catalyst. The V8 engine used an unleaded gasoline (PURA) with known composition and distillation characteristics as a base fue l and with 10% by volume ethanol. The single cylinder engine used a 65% iso-octane - 35% toluene mixture as its base fuel. The engines had essentially the same co mbustion system, with a centrally mounted 6-hole sp rayguided direct injection system. Particle size distr ibutions were recorded and these have also been con verted to mass distributions. Filter samples were taken for t hermo-gravimetric analysis (TGA) to give composition information. Both engines were operated at 1500 rpm under part l oad. The tests with the single cylinder engine use d lambda of 0.9, 1.0 and 1.1 with an ignition timing sweep o f 15-45° bTDC. The trends with the stoichiometric a nd weak mixtures were less clear (the PM emissions being at low levels), but with lambda of 0.9 the trends wer e clear. For the rich mixture, advancing the ignition timing increased both PM number and mass emissions, and the use of E10 reduced the number emissions by a factor of 25-65 and the mass emissions by a factor of 2-10. The V8 tests were at stoichiometric with injection timing sweeps during induction (120 to 360° bTDC), with a reduction in both PM number and mass due to reactions in the catalyst. The earlier injection gave lo wer PM emissions and this was attributed to there being mo re time for mixture preparation, leading to a more homogeneous mixture. The addition of 10% ethanol led to an increase in PM emissions (both in terms of mass and number).