Abstract:Summary form only given. The goal of this work is to design a planar reflectarray antenna to cover a dual-link satellite communication at Ku-band, 12.25 - 12.75 GHz for transmitting and 14 - 14.5 GHz for receiving, respectively. Dual-linear polarization is desired for both bands. Besides, a singler-layer design is targeted for the sake of simplified fabrication, reduced height and decreased loss.For the design of a dual-band reflectarray on a single layer substrate, the traditional way is to have two sets of elements, each individually designed for one band. It works well when the two bands are separated far away from each other, because the coupling between neighboring elements is weak. However, in our design project, since the frequency ratio for the two bands is 1.14, which means the coupling becomes stronger and it is required that element bandwidth shall be narrow that the elements of the 1st band barely changed phases within the 2nd band, and vice versa. It has been shown that although somehow a closely separated dual-band reflectarray could be achieved in this way, the element's bandwidth is too narrow to meet the 0.5 GHz requirement for each band. A novel method, dual-band phase synthesis method, is presented here. By minimizing the total phase error generated from all of the elements, which is the difference between required and achievable phase, a good far-field performance could be obtained at the center frequencies of both bands. Since only one set of elements was used by this method, the coupling problem in the traditional method is not an issue in the current design. As long as the element is properly selected, a dual-band reflectarray achieving 0.5 GHz bandwidth for each band could be realized. Not only a dual-band reflectarray could be obtained, by choosing an element with wider bandwidth, a wide-band relfectarray can also be designed with this method for a bandwidth large enough to cover both required bands. Comparison of traditional method and the novel method presented here, as well as the bandwidth performance with narrow and wide band elements, were shown in the presentation.

Parameter Design of the Two Vertical Arrays System for Separation of Eigenrays in Shallow Water Environment

Near-field beamforming for a Multi-Beam Echo Sounder: Approximation and error analysis

Signal Processing Algorithm and System Realization of Broadband Parametric Array Sub-Bottom Profiler

Multi-Frequency Transmitting Beamforming Algorithm Based on Cross Array

Design of Portable Three-Dimensional Sonar for Both Far-Field and Near-Field

Cross Power Spectral Density Based Beamforming for Underwater Acoustic Communications

An Efficient Near-Field Parallel Subarray Beamforming for Portable 3D Imaging Sonar

High-Performance Broadband Bistatic Piezoelectric Composite Array for Application in Ship Wake Detection

A Method For The Towed Line Array Sonar'S Port-Side/Starboard-Side Discrimination

Geometry design of two-dimensional non-filled array for multimode separation in skywave radar

Research and Design of Underwater Broadband Beamforming System Based on the Parametric Acoustic Array

Design of Horizontal Airspace Dividing Radar Antenna Array

Closely Separated Dual-Band Reflectarray Design for Satellite Communications

Poster Abstract: Voxnet Acoustic Array For Multiple Bird Source Separation By Beamforming Using Measured Data

High-performance deep-sea long-range underwater acoustic communication: Deconvolved conventional beamforming based approach

Ionosphere interference suppression for HFSWR using L-shape array

Nested Array Sensor With Grating Lobe Suppression and Arbitrary Transmit–Receive Beampattern Synthesis

Analysis of Key Parameters of Spatial Power Combination of Sparse Array Time Reversal Signals

Nested Array Sensor With Grating Lobe Suppression and Arbitrary Transmit-Receive Beampattern Synthesis.

5.4 A 22.4-to-30.7ghz Phased-Array Receiver with Beam-Pattern Null-Steering and Beam-Tracking Techniques Achieving >30.2db OTA-Tested Spatial Rejection

Research On The Fast Direction Estimation And Display Method Of Far-Field Signal