Abstract:Distributed fiber-optic sensing (DFOS) technologies have been used for decades to detect damage in infrastructure. One recent DFOS technology, Optical Frequency Domain Reflectometry (OFDR), has attracted attention from the structural engineering community because its high spatial resolution and refined accuracy could enable new monitoring possibilities and new insight regarding the behavior of reinforced concrete (RC) structures. The current research project explores the ability and potential of OFDR to measure distributed strain in RC structures through laboratory tests on an innovative beam–column connection, in which a partial slot joint was introduced between the beam and the column to control damage. In the test specimen, fiber-optic cables were embedded in both the steel reinforcement and concrete. The specimen was tested under quasi-static cyclic loading with increasing displacement demand at the structural laboratory of the Pacific Earthquake Engineering Research (PEER) Center of UC Berkeley. Different types of fiber-optic cables were embedded both in the concrete and the rebar. The influence of the cable coating and cable position are discussed. The DFOS results are compared with traditional measurements (DIC and LVDT). The high resolution of DFOS at small deformations provides new insights regarding the mechanical behavior of the slotted RC beam–column connection, including direct measurement of beam curvature, rebar deformation, and slot opening and closing. A major contribution of this work is the quantification of the performance and limitations of the DFOS system under large cyclic strains. Performance is quantified in terms of non-valid points (which occur in large strains when the DFOS analyzer does not return a strain value), maximum strain that can be reliably measured, crack width that causes cable rupture, and the effect of the cable coating on the measurements. Structural damage indices are also proposed based on the DFOS results. These damage indices correlate reasonably well with the maximum sustained drift, indicating the potential of using DFOS for RC structural damage assessment. The experimental data set is made publicly available.

Distributed strain measurement of a large-scale reinforced concrete beam-column assembly under cyclic loading

The study on prestressed cable stress based on Brillouin-optictime optic fiber sensor

A Novel Method of Embedding Distributed Optical Fiber Sensors for Structural Health Monitoring

An Optical Fiber Sensor Method for Simultaneously Monitoring Corrosion and Structural Strain Induced by Loading

Distributed Fiber-Optic Strain Sensing of an Innovative Reinforced Concrete Beam–Column Connection

Spiral Deployment of Optical Fiber Sensors for Distributed Strain Measurement in Seven-Wire Twisted Steel Cables, Post-Tensioned against Precast Concrete Bars

Quantitative strain measurement and crack detection in RC structures using a truly distributed fiber optic sensing system

Monitoring the stress of the post-tensioning cable using fiber optic distributed strain sensor

Deformation measurement based on high resolution distributed optical fiber sensing and conjugated beam method

Full Scale Strain Monitoring of A Suspension Bridge Using High Performance Distributed Fiber Optic Sensors

Performances of Distributed Fiber Optic Strain Sensor with Thin-Walled Ring

Experimental Analysis on Real-time Distributed Strain Measurement in Concrete

Experimental Investigation of RC Beams Using BOTDA(R)-FRP-OF

Application of a Distributed Optical Fiber Sensing Technique in Monitoring the Stress of Precast Piles

Embedded Distributed Optical Fiber Sensors in Reinforced Concrete Structures—A Case Study

Monitoring Flexure Behavior of Compacted Clay Beam Using High-Resolution Distributed Fiber Optic Strain Sensors

Experimental study on the deformation monitoring of reinforced concrete T-beam using BOTDR

Application of Distributed Fibre Optical Sensing in Reinforced Concrete Elements Subjected to Monotonic and Cyclic Loading

Study on RC Beams Using BOTDA(R)-FRP-OF Technique

Distributed Impact Wave Detection in Steel I-Beam with a Weak Fiber Bragg Gratings Array

Distributed fiber optic sensing for internal strain monitoring in full life cycle of concrete slabs with BOFDA technology