Abstract:Simultaneous switching noise (SSN, also called delta-I noise) has become a tremendous challenge to the reliable operation of high speed electronic circuits. Etching narrow slots on the power or ground plane is one of the efficient techniques to isolate the SSN. A new method for modeling SSN of power-ground planes with narrow slot is proposed in this paper. Firstly, the gapped power-ground planes characteristic is derived from a hybrid field-circuit method. This method makes a full use of the gapped power-ground planes physical structure, takes into account both the parallel power-ground planes characteristic and slot coupling effect in one model. Then, the frequency domain transfer function between two ports of power-ground planes can be obtained from this model. Secondly, in order to overcome the conventional fast Fourier transform inevitable flaws, the vector fitting technique is used to approximate the transfer function as a rational function. Finally, the SSN voltage can be derived from this rational function and exciting current.

Hierarchical Modeling Of Sigma Delta Modulators For Noise Coupling Analysis

Behavioral Modeling of Third- order Cascaded Sigma - delta Modulators

Behavioral Modeling for Operational Amplifier in Sigma-Delta Modulators with Verilog-A.

A simple approach to modeling substrate coupling in mixed-signal integrated circuits by TCAD

Modeling of a 200 KHz Bandwidth Low-pass Switch-capacitor Sigma-delta DAC with a Raised Spur-free Modulator

Noise Transfer Function Design of High - Order Delta - Sigma Modulators

A New Modeling Method of MEMS System's Noise

3d Hybrid Modeling Of Substrate Coupling Noise In Lightly Doped Mixed-Signal Ics

Modeling Of Substrate Coupling Noise In Lightly Doped Mixed-Signal Ics

Modeling of the Simultaneous Switching Noise in High Speed Electronic Circuit with the Integral Equation Method and Vector Fitting Method

Integral-Equation Equivalent-Circuit Method for Modeling of Noise Coupling in Multilayered Power Distribution Networks

Analysis and Simulation of Oversampling Sigma Delta Modulator

Methodology to Determine Dominant Noise Source in a System-on-chip Based Implantable Device

3D RC modeling of substrate coupling noise in high-speed Flash A/D converters

Modeling the simultaneous switching noise with the integral equation method and vector fitting method

Behavioral Modeling of Non-Ideal Σ-A Modulator in SIMULINK

A new op-amp noise model for switched-capacitor sigma-delta modulator in SIMULINK

System Level Power Optimization of Sigma-Delta Modulator

Design Of High-Order Sigma-Delta Modulator For Bist Of Mixed-Signal Integrated Circuits

Behavioral Simulation of Sigma-Delta Modulator in SIMULINK

Modeling and Simulation to the Design of ΣΔ Fractional-N Frequency Synthesizer