Abstract:It is commonly understood that a 2-D slope stability analysis will provide a lower factor of safety than a 3-D slope stability analysis. The difference in the calculated factors of safety between a 2-D and a 3-D analysis is generally less than 15% for simple slope geometries. Most past comparative studies between 2-D and 3-D stability analyses have ignored the effect of negative pore-water pressures (i.e., matric suctions) in the soil zone above the groundwater table. In this paper, a comparison is made between 2-D and 3-D slope stability analyses on soil slopes where a portion of the soil profile has matric suctions. The factors of safety on simple geometry slopes and complex geometry slopes (i.e., slopes which have two intersecting slope surfaces), are investigated for a range of shear strength parameters and groundwater conditions. For simple slopes with a low slope angle, the difference in factor of safety between a 2-D and a 3-D slope stability analysis, (i.e., ΔFs/Fs2-D), generally ranges from 9% to 16% when ϕb is equal to 15°. The value of ΔFs/Fs2-D for a steep, simple slope is generally larger than for a low angle, simple slope. When ϕb is 15°, the values of ΔFs/Fs2-D for the simple, steep slope generally range from 12 to 18%. The difference between a 2-D and a 3-D stability analysis was most pronounced for concave geometries where a portion of the soil profile contained unsaturated soils. The values of ΔFs/Fs2-D for corner angle concave slopes with angles ranging between 180 to 270° can be as large as 20 to 59% when ϕb is equal to 15°. Two case histories, (i.e., the highwall stability failure at the Poplar River coal mine and the Kettleman Hills landfill slope failure), were used to illustrate the effect of the unsaturated zone on changes in the factors of safety.

Analytical Solution for Slope Instability Assessment Considering Impact of Confined Aquifer

Analytical calculation of the critical inclination of rock slopes with a planar failure surface under water pressure

Slope Stability Analysis Using Slice-Wise Factor of Safety

Analysis of Slope Failure Mechanism Caused by Uplift of Confined Water

The Influence of Localized Slumping on Groundwater Seepage and Slope Stability

INFLUENCE OF CONFINED WATER ON TRANSLATIONAL LANDSLIDE

Stability of slopes in partially saturated soils: Incorporating the combined effects of seismic forces and pore water pressure

Stability analysis of reservoir slopes under fluctuating water levels using the combined finite-discrete element method

Influence of Reservoir Water Level Fluctuations on Stability of Unsaturated Soil Banks

Stability Analysis of Overconsolidated Unsaturated Red Clay Slope Based on Modified UH Model

A Displacement-Based Method for Evaluating the Stability of a Pile-Stabilized Slope

A Siphon Drainage Method for Stabilizing Bank Slopes under Water Drawdown Condition

An analytical solution for rainfall infiltration into an unsaturated infinite slope and its application to slope stability analysis

Temporary Confined Water-Induced Landslide in the Binary Structure of a Gentle Slope: A Case Study of the Fanshantou Landslide

A Case Study of a Rainfall-Induced Landslide Involving Weak Interlayer and Its Treatment Using the Siphon Drainage Method

The influence of the unsaturated soil zone on 2-D and 3-D slope stability analyses

Seepage and Stability Analysis of Bank Slopes

The overall stability of a partially unstable reservoir bank slope to water fluctuation and rainfall based on Bayesian theory

Analysis of Partially Saturated Clayey Slopes Using Finite Element Method

Evaluation of Interslice Force Function and Discussion on Convergence in Slope Stability Analysis by the Lower Bound Method

Stability Analysis of a Water‐Rich Slope Under Seismic Disturbance