Abstract:The virtual fields method (VFM) is a novel highly efficient non-iterative tool for the identification of the constitutive parameters of materials. The VFM can obtain several constitutive parameters based on the full-field deformation of the specimen measured in a single test. However, the available results demonstrate that the accuracy of the identification result is strongly dependent on the quality of the deformation field, which is generally measured using optical methods. Especially, in the case where a small deformation is applied under elastic loading, the image noise and measurement error will exhibit a significant influence on the identification results. By combining the VFM with moiré interferometry (MI), a MI-based VFM is used to identify the parameters of an orthotropic linear elastic material. A numerical experiment is conducted to examine the feasibility of this method. From the analysis results, we determine that two factors exhibit an influence on the identification accuracy. The reinforcement direction of the orthotropic material is one factor, and the other is the noise in the deformation field. This MI-based VFM is then applied to determine the mechanical parameters of a unidirectional carbon fiber composite material. In the measurement, a three-point bending load is applied to the specimens. A high density grating with a frequency of 1200line/mm grating is replicated on the specimen surface and used for measuring the in-plane deformation fields using a moiré interferometer. The obtained deformation fields are taken as the inputs of the VFM identification process, and the elastic properties of the materials are identified. The obtained results verify the advantage of the proposed method with respect to high accuracy and good noise immunity.

Identification of Low Density Polyurethane Foam Properties by DIC and the Virtual Fields Method

Mechanical Performance of Polystyrene Foam (EPS): Experimental and Numerical Analysis

Méthodologie D'identification Du Comportement Mécanique Des Mousses Hyperélastiques Par Mesures De Champs Et Méthode Inverse

Impact Testing of Polymeric Foam Using Hopkinson Bars and Digital Image Analysis

Measurement and identification of dynamic properties of flexible polyurethane foam

Elastic Stiffness Characterization Using Three-Dimensional Full-Field Deformation Obtained with Optical Coherence Tomography and Digital Volume Correlation

Elastic Property Evaluation of Fiberglass and Epoxy Resin Composite Material Using Digital Image Correlation

Application of digital image correlation to measurement of packaging material mechanical properties

Mechanical Characterization and Numerical Modeling on the Yield and Fracture Behaviors of Polymethacrylimide (PMI) Foam Materials

A Study of Experimental Method for Mechanical Properties of Rigid Polyurethane Foam under Hydrostatic Compressive Loading

High fidelity simulation of the mechanical behavior of closed-cell polyurethane foams

Assessment of Multiaxial Mechanical Response of Rigid Polyurethane Foams

Special Stereo-digital image correlation method for meterial constitutive parameter identification

Characterization of Stress-Strain Behavior of Composites using Digital Image Correlation and Finite Element Analysis

Experiments and parameter identification for the stress-strain relation of polyurethane foam

An experimental toolbox for the physical characterization of thermal insulating polymeric foams

Full-Field Deformation Measurement Via One Element Q-DIC

Identification of the Elastic Stiffness of Composites Using the Virtual Fields Method and Digital Image Correlation

Shear characterization in soft polyurethane foams: A critical comparison among experimental approaches

Virtual fields method coupled with moiré interferometry: Special considerations and application

Quasi-static Studies of Deformation, Fracture and Mechanical Properties of a PBX Simulant Using Digital Image Correlation Method