Abstract:A composite titania thin film consisted of quasi-aligned single-crystalline rutile nanorods embedded in sol-gel-derived anatase aggregates was fabricated and its photoelectrochemical behavior was studied in detail. A monolayer of nearly sing I e-crystal line rutile nanorods was first deposited on metallic Ti substrates through a controlled reaction between Ti and hydrogen peroxide. The gaps among the rutile nanorods were then filled with titania nanoparticles through a sol-gel dip-coating approach, which achieved a composite thin film of single-crystalline rutile nanorods embedded in anatase aggregates, after a subsequent thermal treatment at 723 K. The X-ray diffraction measurement revealed that the composite film with thickness of 180 nm contained anatase and rutile in a nearly 50:50 ratio. The UV-visible diffusive reflectance spectra estimated a band gap of 2.99 eV for the rutile monolayer and a slightly increased value of 3.03 eV for the composite film due to the embedding of the anatase nanoparticles. Photocurrent versus potential diagrams, photocurrent transient curves, and open-circuit potential measurement supported the fact that the anatase nanoparticles possessed better inherent photoelectrochemical properties than rutile. However, electrochemical impedance spectra characterization, together with photocurrent transient curves and open-circuit potential measurement, suggests that the single-crystalline rutile nanorods exhibited a higher electron-transfer rate. The combination of the two components in such an appropriate way enhanced significantly the charge separation effect arising from the anatase/rutile couple, which hence combined efficiently the "mixed crystal effect" and the "mixed morphological effect". A steady-state photocurrent more than double the simple sum of those generated by the two components alone was detected for the current composite film, which can be attributed to the single-crystalline rutile nanorods that provide channels for rapid electron transfer to the conductive Ti substrates under an applied bias potential. As a result, this study concludes that the present nanostructure magnified significantly the well-established mixed crystal effect, that is, an enhanced charge separation arising from a mixture of anatase and rutile.

The Effect of Introduced Method of Titania and Applied Potential on the Photoelectrocatalytic Properties of Cnt/Tio(2)Electrodes

Electro-Chemical Preparation of Tio2/Cnt Electrodes with Tnb Electrolyte and Their Photoelectrocatalytic Effect

Electrodeposited Cu2O on the {101} Facets of TiO2 Nanosheet Arrays and Their Enhanced Photoelectrochemical Performance

Fabrication and characterization of photoelectrocatalytic electrodes of carbon nanotube/titanium oxide

Synthesis and Characterization of Cnt / Tio2 Photoelectrocatalytic Electrodes for Methlene Blue Degradation

Enhanced Photoelectrochemical Properties of Nanocrystalline TiO2 Electrode by Surface Sensitization with CuxO Quantum Dots.

Characterization of CNT/TiO2Electrode Prepared Through Impregnation with TNB and Their Photoelectrocatalytic Properties

Optimization of Cds/Tio2 Nanotube-Array Composite Photocatalysts Prepared by Electrodeposition

Electro-chemical preparation of TiO2/ACF composites with TNB electrolyte anal their photocatalytic effect

Fabrication of CNT/TiO2 electrodes and their photoelectrocatalytic properties for methylene blue degradation

Synthesis of Co3O4/Ag/TiO2 Nanotubes Arrays Via Photo-Deposition of Ag and Modification of Co3O4 (311) for Enhancement of Visible-Light Photoelectrochemical Performance

Enhanced Photoelectrochemical Response of a Composite Titania Thin Film with Single-Crystalline Rutile Nanorods Embedded in Anatase Aggregates

Influence of the Potential on the Charge-Transfer Rate Constant of Photooxidation of Water over Α-Fe2o3 and Ti-Doped Α-Fe2o3

Photoelectrocatalytic Degradation of Dyes in Aqueous Solution Using CNT/TiO2Electrode

Fabrication of M-Cnt/Tio2 (m=cr, Mn and Fe) Composites and the Effect of Transition Metals on Their Photocatalytic Activities

Fabrication and Electro-Photolysis Property of Carbon Nanotubes/Titanium Composite Photocatalysts for Methylene Blue

Preparation And Photocatalytic Effect Of Mwcnt/Tio2 Composites

Electrochemical Method for Synthesis of a ZnFe2O4/TiO2 Composite Nanotube Array Modified Electrode with Enhanced Photoelectrochemical Activity

Photoelectrochemical Activity of TiO 2 /MWCNT Thin-Film Electrodes with Different Film Structures Prepared by Combining Electrophoretic Deposition and Sol–Gel Method

Investigation on the Photoelectrocatalytic Activity of Well-Aligned Tio2 Nanotube Arrays

Photonic effects of Mn-CNT/TiO 2 composites modified by different oxide agents