Abstract:Titania-based nanocomposites have recently attracted much attention due to their unique structure and properties. Titania has been known to have three crystal phases: brookite, anatase and rutile. The anatase titania has the highest photoactivity than the other two phases. Meanwhile Ohtani et al. [1] reported that amorphous titania has a negligible photoactivity compared to the crystalline titania. Much work has been conducted on the optimization of catalytic properties of titania used in the photodegradation of organic pollutants in water by either using modified titania or thin titania films. Many researches indicated that dopants, such as many oxides, can effectively suppress the transformation of anatase into rutile by improving the onset transformation temperature [2]. Silica-titania mixed oxide is considered a potential candidate because it is used as not only a good photocatalyst itself but also a support material for other chemical reaction catalysts [3, 4]. 30SiO2/TiO2 powders (30 denotes the weight percent of silica) were prepared by sol-gel process. Ti(OBu n )4 and TEOS were used as precursors of titania and silica respectively. After TEOS was stirred in a mixture solution of pure ethanol, distilled water and hydrochloric acid for 1 h, Ti(OBu n )4 was added slowly into the mixture. The sol of SiO2/TiO2 was obtained after another two hours’ vigorous stirring and cooled to room temperature. The gel was calcined at different temperatures and then ground into fine powders. The distilled water solution of methyl orange (with a concentration of 25 mg/L) was chosen for photodegradation. 0.2 g powders were added into 40 ml of the above solution with vigorous agitation under the mercury light. A 756MC UV-VIS spectrometer was used to record the change of concentration of the methyl orange. FT-IR spectra was obtained by a Bruker EQUINOX55 spectrometer. TEM and HREM observations were carried out using a Jeol-2010 electron microscope. The XRD patterns were made in a D/max3A diffractometer with Cu Kα radiation. The crystallite size of powders was determined by Scherrer equation. Electron spin resonance measurements were made with a Bruker paramagnetic spectrometer. X-ray photoelectron spectroscopy (XPS) spectra of the sample were obtained with an NP-1 using the Mg Kα excitation source and the binding energies referenced to the C1s hydrocarbon line at 284.6 eV. The atomic ratios were obtained by intergrating the areas under the peak. Photodegradation for methyl orange with 30SiO2/ TiO2 samples calcinated at different temperature under UV irradiation is illustrated in Fig. 1. The results of other samples heated at temperatures higher than 850 ◦ C were not shown in this figure because further increase of the calcination temperature decreased the decomposition rate. It can be seen that decomposition rate of the samples fired at 400 ◦ C and 500 ◦ Ci s low. When the calcination temperature was further increased to 600 ◦ C, the higher photoactivity than Degussa P25’s was obtained. The sample heated at 800 ◦ C has the best photoactivity about 2 times higher than the Degussa P25.

Facile flame thermal synthesis of SiOx-C/ TiO2 microspheres with enhanced photocatalytic performance

Synthesis and Photocatalytic Property of SiO2/TiO2

Preparation of SiO2@Au@TiO2 Core–shell Nanostructures and Their Photocatalytic Activities under Visible Light Irradiation

Facile Synthesis of Novel Fe3O4@SiO2@mSiO2@TiO2 Core-Shell Microspheres with Mesoporous Structure and Their Photocatalytic Performance

Facile Fabrication of Mesoporous SiO2@(cTiO2/BiOI) Heterojunctions with Enhanced Photocatalytic Properties Due to Large Surface Area for Contact with Pollutants

A high-stability silica-clay composite: synthesis, characterization and combination with TiO2 as a novel photocatalyst for Azo dye.

Facile Fabrication of Mesoporous SiO2@(cTiO2/BiOI) 2 @(ctio 2 /bioi) Heterojunctions with Enhanced Photocatalytic Properties Due to Large Surface Area for Contact with Pollutants

A Simple Solvothermal Process to Synthesize CaTiO3 Microspheres and Its Photocatalytic Properties

Fabrication of hydroxyl group modified monodispersed hybrid silica particles and the h-SiO2/TiO2 core/shell microspheres as high performance photocatalyst for dye degradation

Enhanced photoactivity of silica-titania binary oxides prepared by sol-gel method

Hydrolytic Modification of SiO2 Microspheres with Na2SiO3 and the Performance of Supported Nano-TiO2 Composite Photocatalyst

Aerosol-assisted flow synthesis of WxTi1-xO 2 solid solution spheres with enhanced photocatalytic activity

Homogeneous Synthesis of SiO2@TiO2 Nanocomposites with Controllable Shell Thickness and Their Enhanced Photocatalytic Activity.

Facile Synthesis of SiO 2 @tio 2 Hybrid NPs with Improved Photocatalytic Performance

Synthesis of Ti3+ self-doped mesoporous TiO2 cube with enhanced visible-light photoactivity by a simple reduction method

Facile Synthesis of Co3O4 Nanoparticle-Functionalized Mesoporous SiO2 for Catalytic Degradation of Methylene Blue from Aqueous Solutions

Mesoporous hollow sphere titanium dioxide photocatalysts through hydrothermal silica etching

Development and Upscaling of SiO2@TiO2 Core-Shell Nanoparticles for Methylene Blue Removal

Preparation of TiO2 Composite Photocatalyst Using Amorphous SiO2 Microspheres Loaded with Spent SCR Catalysts

Synthesis of Highly Monodispersed Teardrop-Shaped Core–shell SiO2/TiO2 Nanoparticles and Their Photocatalytic Activities

Synthesis of rattle-type magnetic mesoporous Fe3O4@mSiO2@BiOBr hierarchical photocatalyst and investigation of its photoactivity in the degradation of methylene blue