Abstract:A numerical model of an iron bath smelting reduction furnace with side-bottom combined blowing was established to study the influence of blowing arrangements on the stirring effect of the molten pool, and the accuracy of numerical simulation was verified by water model experiment. By comparing the flow field of molten pool with single nozzle, double nozzles (symmetrical and asymmetrical), and four nozzles (symmetrical and asymmetrical), the proportion of dead zone, average turbulent kinetic energy, and mixing time, the results show that asymmetrical bottom blowing is better than symmetrical bottom blowing, and the effect of double nozzles bottom blowing was better than that of four nozzles bottom blowing. The mixing effect is the worst under the condition of single nozzle. When the bottom blowing is asymmetrical with double nozzles, the mixing time is the shortest. Under the condition of double nozzles asymmetrical bottom blowing, when the insertion angle and depth of side lance are larger and deeper, the velocity streamline of molten slag layer is denser and the value is larger; meanwhile, the reflux of molten iron layer is larger, the proportion of dead zone is smaller, and the whole molten pool is fully stirred. When the insertion depth of the side lance is deeper, the gas holdup in the molten pool is greater and the stirring of the molten pool is more intense, while the insertion angle has little effect on the gas holdup. By comparing the influence of different side blowing conditions on the slag layer, it is found that the slag layer is divided into two layers by double-layer side lance, with the critical surface of the slag layer at about 200–260 mm from the bottom, and the insertion depth of the lower side lance has a greater influence on the layering of the slag.

Numerical Simulation for the Splashing Behavior in an Oxygen Converter Process

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Numerical Simulation of the Slag Splashing Process in A 120 Ton Top-Blown Converter

Numerical Study on Droplet Splashing Behavior of Slag‐Splashing for Converter Protection Using Volume of Fluid‐Discrete Phase Model Two‐Way Conversion Model

Enhanced impingement characteristics of supersonic oxygen jets on molten bath using a multi-nozzle oxygen lance in a converter

Numerical Simulation of CO2 Used for Slag Splashing Process in Converter

Numerical Simulation of the Interaction Between Supersonic Oxygen Jets and Molten Slag–Metal Bath in Steelmaking BOF Process

Mathematical Modeling on the Multiphase Flow during Top–Bottom Combined Blowing Basic Oxygen Furnace Steelmaking Process

Numerical Simulation of Heat Transfer Behavior in Hot Spot Zone of Converter Molten Bath

Numerical Simulation of Temperature and Velocity Field in All-Oxygen Combustion

Numerical Simulation for Combustion of Droplet with Volume of Fluid Formulation

Simulation of Fluid Flow in the Top–Bottom Combined Blowing Converter

Optimize the Operation Parameters in Surging Auxiliary Slag Skimming Process Based on Large Eddy Simulation –Volume of Fluid –Discrete Phase Model Coupled Model

A coupled mathematical model and experimental validation of oxygen transport behavior in the electro-slag refining process

Numerical Simulation of Combustion Process for a Slag Tapping Boiler

Numerical Simulation of Multiphase Flow in Ironmaking Process for Oxygen-Rich Side-Blown Bath Smelting Furnace

Numerical Simulation on Process of Heterogeneous Mass Transfer of Oxygen in Stirred Tank

Effect of Furnace Gas Composition on Characteristics of Supersonic Oxygen Jets in the Converter Steelmaking Process

Numerical simulation of flow characteristics of side-bottom combined blowing in iron bath reactor

Simulating and Evaluating the Multiphase Jet Flow Characteristics of a Five‐Hole Oxygen Lance under Nonisothermal Conditions

Numerical investigation of liquid oxygen filling process in liquid rocket engine by a multi-dimensional co-simulation method