Abstract:The discrete cohesive zone model (DCZM) is implemented using the finite element (FE) method to simulate fracture initiation and subsequent growth when material non-linear effects are significant. Different from the widely used continuum cohesive zone model (CCZM) where the cohesive zone model is implemented within continuum type elements and the cohesive law is applied at each integral point, DCZM uses rod type elements and applies the cohesive law as the rod internal force vs. nodal separation (or rod elongation). These rod elements have the provision of being represented as spring type elements and this is what is considered in the present paper. A series of 1D interface elements was placed between node pairs along the intended fracture path to simulate fracture initiation and growth. Dummy nodes were introduced within the interface element to extract information regarding the mesh size and the crack path orientation. To illustrate the DCZM, three popular fracture test configurations were examined. For pure mode I, the double cantilever beam configuration, using both uniform and biased meshes were analyzed and the results show that the DCZM is not sensitive to the mesh size. Results also show that DCZM is not sensitive to the loading increment, either. Next, the end notched flexure for pure mode II and, the mixed-mode bending were studied to further investigate the approach. No convergence difficulty was encountered during the crack growth analyses. Therefore, the proposed DCZM approach is a simple but promising tool in analyzing very general two-dimensional crack growth problems. This approach has been implemented in the commercial FEA software ABAQUS® using a user defined subroutine and should be very useful in performing structural integrity analysis of cracked structures by engineers using ABAQUS®.

A Thermodynamically Consistent Cohesive Zone Model for Mixed-Mode Fracture

A thermodynamically consistent phase field model for mixed-mode fracture in rock-like materials

Discrete Cohesive Zone Model for Mixed-Mode Fracture Using Finite Element Analysis

A String-Based Cohesive Zone Model for Interlaminar Delamination

A Phase-Field Framework for Modeling Multiple Cohesive Fracture Behaviors in Laminated Composite Materials

A novel and simple variationally-consistent phase-field cohesive zone model for mixed-mode fracture

Phase-field method with additional dissipation force for mixed-mode cohesive fracture

Cohesive zone modeling for viscoplastic behavior at finite deformations

Rock fracture propagation in a damage zone by a constitutive model coupling volume and cohesive elements

A Phase-Field Model for Mixed-Mode Fracture Based on a Unified Tensile Fracture Criterion

A rate-dependent cohesive zone model with the effects of interfacial viscoelasticity and progressive damage

Recent Advances in Cohesive Zone Modelling of Fracture

Applications of Normal Stress Dominated Cohesive Zone Models for Mixed-Mode Crack Simulation Based on Extended Finite Element Methods

A New Mechanism Based Cohesive Zone Model for Mode I Delamination Coupled with Fiber Bridging of Composite Laminates

A Generalized Phase-Field Cohesive Zone Model (Μpf-Czm) for Fracture

DAMAGE LAWS OF COHESIVE ZONE MODEL AND SELECTION OF THE PARAMETERS

A phase-field model for mixed-mode cohesive fracture in fiber-reinforced composites

Verification Of A Cohesive Zone Model For Ductile Fracture

Assessment of low cycle fatigue crack growth under mixed-mode loading conditions by using a cohesive zone model

Phase-field cohesive fracture theory: A unified framework for dissipative systems based on variational inequality of virtual works

A 2D Generic Multi-Surface Cohesive Zone Model for Simulating FRP-to-concrete Mixed-Mode Debonding Failure