Abstract:The soft surrounding rock of deep roadways is in the state of "micro-fracture and low permeability". In order to solve the problem of grouting reinforcement of micro-fractures surrounding rock in deep roadways, the influence characteristics of auxiliary materials and additives on slurry flow were analyzed, and the composition and proportion of superfine cement-based composite grouting materials were determined: superfine cement accounted for 89.4%, superfine coal ash accounted for 5%, ultrafine mineral powder accounted for 5%, naphthalene water reducing agent accounted for 3~5‰, and lignin sulfonate calcium accounted for 1~3‰. The effects of water–cement ratio and water reducer content on slurry viscosity and water bleeding rate were tested by laboratory experiments. Based on the fracture characteristics of surrounding rock and the "Liu Jiacai Formula", the influence law of fracture opening, grouting pressure and slurry viscosity on the slurry diffusion radius was analyzed. The results show that the slurry viscosity decreases with the increase of water–cement ratio and water reducer content, but the bleeding rate increases obviously with the increase of the two factors; when the water–cement ratio is 1.0 and the water reducer content is 3‰, the slurry has the advantages of "strong permeability, strong flow and low water bleeding rate"; the smaller the fracture opening is, the greater the required grouting pressure and the lower the required slurry viscosity. Aiming at the "micro-fracture zone" of surrounding rock in deep roadways, when the dynamic viscosity of the slurry is 2.0 mPa·s, the reasonable grouting pressure should be 12 MPa to meet the needs of grouting reinforcement engineering. The high-pressure grouting test of surrounding rock in the "micro-fracture zone" was successfully carried out by using the superfine cement-based composite grouting material.

Compressibility of Broken Rock-Fine Grain Soil Mixture

Mechanical Properties of Broken Rock-Soil Mixture

Particle Flow Simulations of the Compaction of Filling Materials in Highly Filled Foundation with Analyses of the Transverse Isotropy

Micromechanical Investigation of Suffusion and Its Consequence in Gap-Graded Granular Soil at the Opening of Underground Structures Using the Coupled CFD-DEM Method

Effect of Fines Content on the Compression Behavior of Calcareous Sand

Large Scale Triaxial Testing Of Douposi Moderately-To-Slightly Weathered Fill Materials

Experimental Study on Physical and Mechanical Properties of Mixed Filling behind Retaining Wall

Water Retention Behavior and Shear Strength of Artificially Cemented Granite Residual Soil Subjected to Free Drying

3-D Granular Simulation for Compressibility of Soil-Aggregate Mixture

Some geomechanical properties of soil–rock mixtures in the Hutiao Gorge area, China

A Density-Dependent Constitutive Model of Rockfill as Well as a Dynamic Contact Technique for Simulation of Dynamic Compaction with MPM

Experimental Study on the Performance of Improved Collapsible Loess Mixture with Concrete Crushed Gravel

Fractal Analysis on the Crushing Characteristics of Soil-Soft Rock Mixtures under Compaction

Modeling of gravelly soil with multiple lithologic components and its application

Engineering properties of the compressibility and crushing characteristics of transitional soils mixed with silicate and carbonate sands

Experimental Study on the Effect of Coarse Grain Content on the Dilatancy and Particle Breakage Characteristics of Coarse-Grained Soils

Study on Slurry Flow Characteristics and Diffusion Law of Superfine Cement-Based Composite Grouting Material

An Experimental Investigation of the Mechanical Behavior and Particle Crushing Characteristic of Volcanic Soil

Particle breakage characteristics of coarse-grained soil under point-point contact

Study on large scale direct shear test on soil-rock mixture with multiple grain grades in high fill slope engineering

Standard compression rate test method and its application for rockfill materials