Abstract:The broadband matching network design of underwater acoustic transducer is one of the key technologies for broadband sonar system which can effectively reduce the power loss,expand the working bandwidth of the transducer and improve the distortion of the transmitted waveform.In this paper,a broadband matching network design for multi-resonant mode transducer with the real frequency method was proposed.For underwater acoustic pi-ezoelectric ceramic transducer,the impedance varies with the frequency which is difficult to be expressed by the analytical function.Therefore,it is difficult to achieve good broadband matching performance in a wide frequency range.The traditional broadband matching technology lies on complex analytical theory and analyzes the equivalent circuit of the transducer.In fact,the single inductor matching and multi-resonance method are often used for underwater acoustic transducer broadband matching design,however,the actual matching effect cannot achieve the desired.In the radio field,the theory and method of broadband matching has been well developed,combined with computer aided design(CAD)technology,a series of broadband matching numerical methods applied in the antenna broadband and microwave amplifier matching.The design process was accomplished with computer aided and without equivalent circuit of the load.Taking this advantage,the real frequency direct computational technique is utilized for broadband matching network of underwater acoustic transducer.Firstly,the matching principle of the transducer was briefly discussed,and the theory of Simplified Real Frequency Technique(SRFT)was also discussed. Secondly,the matching network of the pressure pipe transducer was designed.The nonlinear least squares algorithm was used to optimize the transducer power gain(TPG),with the continued fraction expansion method to synthesize wideband matching network.Finally,the matching performance was tested in anechoic pool.The results show that the broadband matching network can improve the transmission efficiency and expend the bandwidth of the transducer.Under the same experimental conditions,compared with the transmitter without matching,the source level of the system increased about 10 dB.Moreover,compared with the transmitter with narrowband matching circuit,the work bandwidth of the transducer is extended about 64%.

Design of Broadband Matching Circuit for Underwater Acoustic Communication Transducer

Application of real frequency technique in broadband matching for underwater acoustic transducer

Piecewise Matching Method of Transducer for Broadband Underwater Acoustic Transmitter System

Dual Resonant Frequency Inductive Power Transfer in an Underwater Tight Coupling System

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Broadband sonar transmission system combined with real frequency data and pre-equalization technology

A Hybrid Impedance Matching Network for Underwater Acoustic Transducers

Design of Broadband Matching Circuit for EMAT Detecting System

Research and Fabrication of Broadband Ring Flextensional Underwater Transducer

The Design Of Impedance Matching Between Long Cable And Ultrasonic Transducer Under Seawater

Ultra-wideband underwater acoustic transducer with a gradient impedance matching layer

Design of Ultrasonic Transducer Structure for Underwater Wireless Power Transfer System

A Broadband Resonant Noise Matching Technique for Piezoelectric Ultrasound Transducers

Research on Low-Frequency Remote Programmable Sound Source System

Broadband Impedance Matching for High Intensity Focused Ultrasound Transducer

Computer Simulation of Sound Field Formed Around Transducer Source Used in Underwater Acoustic Communication

An Adaptive Broadband Active Impedance Matching Network for Underwater Electroacoustic Transduction System

Research on Deep-sea Acoustic Communication Method Based on Directional Transducer

The Design of D-Class Power Amplifier and Matching Circuit

Design simulation and analysis of deep-sea transducer

Influence of Transmitting Directivity on Underwater Acoustic Communication System