Abstract:The application of NMR spin—lattice relaxation measurements of water contained in porous solids is investigated as a possible tool for the determination of pore size distributions. NMR methods have several potential advantages over conventional porosimetry/adsorption techniques including the study of wet porous solids, a wide range of sample sizes that may be studied, and the fact that no pore shape assumption is required. In principle, water contained in a pore will relax faster than bulk water. This decrease in the observed relaxation rate decay constant, T1, is directly related to the pore volume to surface area ratio (i.e., hydraulic radius) according to the “two-fraction, fast-exchange model.” However, the suitability of this model and NMR spin—lattice relaxation measurements for the determination of pore size distributions has not been previously demonstrated. Pore size distributions have been determined for two series of porous solids by mercury porosimetry and a NMR method. A series of four controlled-pore glasses with very narrow pore size distributions and a mean radius in the range 3.4 to 17.6 nm were studied at a frequency of 20 MHz and at four temperatures. By using four samples with similar surface chemistry/ pore shape, the validity of the two-fraction, fast-exchange model was assessed. Experiments were conducted using a 180°–τ-90° pulse sequence and the distribution of T1 was calculated using a nonnegative leastsquares routine (NNLS) presented in a previous paper. The two-fraction model described the change of mean T1 with pore radius at a given temperature. The change of the surface relaxation decay constant, T1s, fit an Arrhenius expression with an activation energy of 1.8 kcal/mole. Agreement between the mercury porosimetry and NMR derived pore size distributions is excellent. T1 measurements at both 20 and 300 MHz and 303 K were also made on a series of porous solids fabricated by pelleting submicron silica spheres. These solids exhibit afairly wide pore size distribution (⋍ one order of magnitude). The two-fraction, fast-exchange model satisfactorily described the relationship between pore size and T1. Agreement between mercury porosimetry and NMR pore size distributions is good. However, the NMR derived distributions consisted of a series of narrow peaks overlapping the single broad porosimetry peak. The surface relaxation effect, and, hence, the overall pore size sensitivity, is increased by a factor of 3 when the proton frequency is decreased from 300 to 20 MHz.

The Assessment of Loosely and Tightly Bound Water in Water Distribution Changes of Human Cortical Bone by NMR

Editorial for “Cortical Bone Mechanical Assessment via Free Water Relaxometry at 3 T ”

The Experimental Study of Quantitative Assessment of Bound and Free Water in Bovine Cortical Bone Using 3D UTE Sequence

Solid-state NMR studies on the organic matrix of bone

Frequency shifts of free water signals from compact bone: Simulations and measurements using a UTE‐FID sequence

Site-specific Quantification of Bone Quality using Highly Nonlinear Solitary Waves

Assessment of Osteoporosis in Lumbar Spine: In Vivo Quantitative MR Imaging of Collagen Bound Water in Trabecular Bone

Application of Low-Field NMR to the Pore Structure of Concrete

A method for vibrational assessment of cortical bone

A comprehensive set of ultrashort echo time magnetic resonance imaging biomarkers to assess cortical bone health: A feasibility study at clinical field strength

Cortical Bone under an Ultrahigh Magnetic Field: Relaxation, Spectroscopy and Micron-resolution Imaging

Laboratory NMR Study to Quantify the Water Saturation of Partially Saturated Porous Rocks

Ultrasound attenuation of cortical bone correlates with biomechanical, microstructural, and compositional properties

Measuring Bone Mineral Density with NMR

Quantitative separation of NMR signal amplitude of water in wood on the basis of T 2

Quantifying early age hydration and micro-structure evolution of fast setting binder using 1 H NMR

A NMR technique for the analysis of pore structure: Application to materials with well-defined pore structure

Proton-Detected Solid-State NMR Spectroscopy of Bone with Ultrafast Magic Angle Spinning

Bone Chemical Composition Assessment with Multi-Wavelength Photoacoustic Analysis

Quantifying Cortical Bone Free Water Using short echo time (STE-MRI) at 1.5T

Micron‐resolution Imaging of Cortical Bone under 14 T Ultrahigh Magnetic Field