Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Flow And Heat Transfer Enhancement In Condensing Water Drops In Steam Flows

Internal Flow and Heat Transfer of A Condensing Water Droplet in Steam Flow

The enhancement effects of internal convection on the heat transport of condensing droplets out of pure steam and moist air

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Flow Characteristic of Steam Jet Condensed into a Water Pipe Flow - a Numerical Study

Thin liquid film flow and heat transfer under spray impingement

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Investigation on Heat Transfer and Flow of a Sonic Steam Jet Condensation in Crossflow of Water in Pipes

Numerical Investigation of Air-Steam Condensation in a Vertically Enhanced Tube with Concave and Convex Surfaces

Interfacial characteristics of steam jet condensation in subcooled water pipe flow - An experimental and numerical study

Flow and Heat Transfer Characteristics of High-Pressure Water Flowing in A Vertical Upward Smooth Tube at Low Mass Flux Conditions

Interfacial Wave Behavior and Its Effect on the Flow and Condensation Heat Transfer in a Microtube

A Review on the Research of Flow and Heat Transfer in Steam Condensing

Research on flow and heat transfer characteristic of over-expanded supersonic steam jet in water

Study on thermodynamics and flow characteristics of jet condensate in subcooled flowing liquid

Experimental study on direct contact condensation of stable steam jet in water flow in a vertical pipe

Jumping Droplet Condensation in Internal Convective Vapor Flow

Liquid film flow boiling heat transfer on cylinder for successive droplets impact

Condensation Characteristics of Flows in Newly Developed, Three-Dimensional Enhanced Heat Transfer Tubes

Experimental Investigation on Heat Transfer Characteristics of Smooth Tube with Downward Flow

Numerical Study on the Nano-Droplets Formation Process from Superheated Steam Condensation Flow Effected by Nozzle Convergent Profile