Abstract:An electrochemical carbon nanotube filter has been reported to be effective for the removal and electrooxidation of aqueous chemicals and microorganisms. Here, we investigate how carbon nanotube (CNT) chemical surface treatments including calcination to remove amorphous carbon, acid treatment to remove internal residual metal oxide, formation of surficial oxy-functional groups, and addition of Sb-doped SnO(2) particles affect the electrooxidative filter performance. The various CNT samples are characterized by scanning electron microscopy (SEM), thermogravimetric analysis (TGA), and X-ray photoelectron spectroscopy (XPS) and electrochemically evaluated by cyclic voltammetry, open circuit potential versus time analysis, and electrochemical impedance spectroscopy. Voltammetry results indicate that the near CNT surface pH is at least two units lower than the bulk pH. The electrooxidative performance of the various CNT samples is evaluated with 1 mM of methyl orange (MO) in 100 mM sodium sulfate at a flow rate of 1.5 mL min(-1). At both 2 and 3 V, the efficacy of electrochemical filtration is observed to be function of CNT surface chemistry. The samples with the greatest electrooxidation were the calcinated then HCl-treated CNTs, i.e., the CNTs with the most surficial sp(2)-bonded carbon, and the Sb-SnO(2)-coated CNTs, i.e., the CNTs with the most electrocatalytic surface area. At 3 V applied voltage, these CNT samples are able to oxidize 95% of the influent MO within the liquid residence time of <1.2 s. The broader applicability of electrochemical filtration is evaluated by challenging the C-CNT-HCl and C-CNT-HNO(3) networks with various organics including methylene blue, phenol, methanol, and formaldehyde. At 3 V applied voltage, both CNTs are able to degrade a fraction of all the organics with the extent organic degradation dependent on both CNT and organic properties. The C-CNT-HCl network generally had the better oxidative performance than the C-CNT-HNO(3) network with an exception being the positively charged methylene blue. The extent of MO degradation, steady-state current, anode potential, effluent pH, and back pressure are also measured as a function of applied voltage (1-3 V) and CNT surface chemistry. Mass spectrometry of electrochemical CNT filter effluent at 2 and 3 V is utilized to evaluate plausible electrooxidation products. Energy consumption as compared to state-of-the-art electrodes and strategies to tailor the CNT surface for a specific target molecule are discussed.

CNT–PVDF Composite Flow-Through Electrode for Single-Pass Sequential Reduction–oxidation

Carbon Nanotube Membrane Stack for Flow-Through Sequential Regenerative Electro-Fenton

Fabrication of a double-layer membrane cathode based on modified carbon nanotubes for the sequential electro-Fenton oxidation of p-nitrophenol

Quantitative Examination of Aqueous Ferrocyanide Oxidation in a Carbon Nanotube Electrochemical Filter: Effects of Flow Rate, Ionic Strength, and Cathode Material

Electrocatalysis aqueous phenol with carbon nanotubes networks as anodes: Electrodes passivation and regeneration and prevention

Boosting Cr(VI) Detoxification and Sequestration Efficiency with Carbon Nanotube Electrochemical Filter Functionalized with Nanoscale Polyaniline: Performance and Mechanism

Electrochemical Carbon Nanotube Filter Oxidative Performance As A Function of Surface Chemistry

A novel electrocatalytic filtration system with carbon nanotube supported nanoscale zerovalent copper toward ultrafast oxidation of organic pollutants

Free-standing membrane incorporating single-atom catalysts for ultrafast electroreduction of low-concentration nitrate

Enhanced Performance of Nitrogen-Doped Carbon Nanotube Membrane-Based Filtration Cathode Microbial Fuel Cell

Electrochemical Carbon Nanotube Filter for Adsorption, Desorption, and Oxidation of Aqueous Dyes and Anions

In-situ combined dual-layer CNT/PVDF membrane for electrically-enhanced fouling resistance

Reactive Depth and Performance of an Electrochemical Carbon Nanotube Network As A Function of Mass Transport

Fouling reduction and recovery during forward osmosis of wastewater using an electroactive CNT composite membrane

Highly Efficient Continuous Flow Nanocatalyst Platform Constructed with Regenerable Bacterial Cellulose Loaded with Gold Nanoparticles and a Nanoporous Membrane

Electrochemical reduction of nitrate in a catalytic carbon membrane nano-reactor

Integrated electrocatalytic packed-bed membrane reactor for nitrate removal

Hydrophobized electrospun nanofibers of hierarchical porosity as the integral gas diffusion electrode for full-pH CO2 electroreduction in membrane electrode assemblies

Carbon nanotube filter functionalized with MIL-101(Fe) for enhanced flow-through electro-Fenton

Reconstructing Electrically Conductive Nanofiltration Membranes with an Aniline-Functionalized Carbon Nanotubes Interlayer for Highly Effective Toxic Organic Treatment

Doped Carbon Nanotube Networks for Electrochemical Filtration of Aqueous Phenol: Electrolyte Precipitation and Phenol Polymerization